Collinjn81, my current problem is a gap when I fitted the monocoque (the one with Aigo on the side). However, I had the same issue as you do. What I did was to tighten the screws below the car even more until the gap closed.

Well elephant glue is cyanoacrylate adhesive which is used in other parts, especially metal components. The official DeA build diary used 5 minute epoxy as well.

Mine has that gap as well, but on the right side. Hopefully it'll even out once I assemble the monocoque onto the main body.

There's an article on this very topic at http://forum.model-space.co.uk/default.aspx?g=posts&t=5227

So far, this is what I have. Got a casing which I give measurement to a shop that doing custom photo frame. Look ok?


Last issue don't have yet, but the car look ready enough.

Hi ckshieh, do you find the engine cover cant fit in well with the rear wing cover, if wana fit nicely then the front engine side cant cover properly, if engine side wana cover properly then the back cant cover nicely with the rear wing. u face this problem? any solution?