smaller manifold less than 300, big manifold less than 400....

This AHM M1 exhaust perang.....haha.....

But AHM M1 also with silencer right? Perang also ar...?

With silencer like nobi..Without silencer....My yoshi also cannot hear...
>_< Mental M1 totally cover my yoshi when he high rev... ><

Yoshi alrd so loud.. If can cover yoshi mean very loud lei.

No la..>XD Yoshi actually not too loud...I think i will buy a silencer for yoshi in some time....XD Sometimes also need some quite ride..XD ...Plant to do a volt stabilizer and maybe rebore again my ori carb....Now feel power doesn't enough already...>< Maybe do clean the head or wat...><

hmmm plan not to get for lousy wan, compare this three yoshi, nob1 n ahm1 which hav less scream, i prefer using as standard but oso wan a little bit perfomance....

Erm...then try to operate the pipe if u ori engine...But u got modify engine..I suggest change to M1 or others..

Dragorc: Of course nob 1 less scream it only will scream when u pull throttle hard.

016: mean you need to change bigger block la no need rebore d. Yoshimura carbs and yoshimura pipe sure will be nice couple lei.

I means re-bore again carb la..XD I knew it but yoshi carb really makes me wan to jump...1.5k a carb?? No way..exp like 26mm mikuni Rm400 and really import from jp ok la...Or not i still prefer using uma carb or others bike carb...

That day i got see a ori carbs from Japan at penang area. Is a New TM24 flat slide RM400+. Got writting there put mikuni corp Japan. But the mechanic say too small for LC but its still big than our ori carbs. It look the almost same like UMA also.

Hello...

I'm new here~~

Actually...I really wanna know...

Does anyone here know how to modify the standard exhaust for LC135?

I mean that,not to send it to any workshop,but,done it by our own hand,or called as DIY.Does anybody have any knowledge on it?

This post has been edited by mr.[L]: Sep 23 2011, 03:53 PM

ya ... i rmb tht .. got 2 size ..smaller and bigger

got such problem ? my bearing housing still fit fit ... mayb during pasang and ketuk out .. cause it ...


rebore ur carb again ? u better dun waste money liao .... try change ur clutch spring .... see see


no need use those flat slide ... go gorek rxz , NSR , Tzm & uma carb ... set cun .. with correct fomula .. garanty powder mari

stapak , PJ , shah alam also got those operate pipe shop ...( use ur std pipe to mod )

Just get bored on only buy,then PnP only my perang exhaust =.='

really want to try on something new like doing it by myself,that's whyI'm asking how to done it.haha

Anyway...how much price for YYpangSP with long muffler right now eh??

go operate ur pipe ... and u try ..

later i go get the yypang or ahm ....

If it is your first time better not risk it. Just get a shop to do it then you see how they do it.

if u haven kacau engine ... use std pipe go operate it ...

sudah kacau .. better go get aftermarket pipe ... risk is takut sangkut JPJ , trafic , polis jer

can i know what's the exact pressure do i need to pump up my rear and front tyre...because recently i found that my rear tyre is some kind like being flat..is it 'bocor'?

Change clucth spring? Y?

go shop check ur tyre .. bro

if bocor just tampal it or need to replace new tyre?..how much does it cost for it?