Before sleeving:


After:


Need you guys to give some suggestions to hide those curly cables on the front.
Casing is a small little LL PCA05, really have no idea how to hide them... they look like curly worms.

This post has been edited by pmmonkey: Mar 2 2008, 03:08 PM

that ram cooler will be used during oc. Sit above the hr07.

Hmm... I'm using the flat IDE cable which came with abit mobo.
My messy cable problem is due to sata power, ide was well folded and hidden.

You surely can sleeve the psu yourself.
First time will be a little hard cos you're not familiar of how to do it.
After a few lines, it'll be easier.
First time took me long to finish a whole psu. My second time, in just a few hours.
I'm sure you can do it too.

Hmm... I see many users for this casing despite the position of the psu which cause difficulties in cable management.

The 4/8pin atx seems thick, nonetheless still can be done. Since sleeving looked loose, can probably flatten it abit.

Another choice is to slip it into the hole between the graphics card and the mobo. There should be a hole there after the pcie slot.

Btw, can the psu be turned 180degrees so that the cables are towards the inside?

Spent most of my time yesterday cleaning up my pc.
Redone my cables, sleeved up everything which I didn't.
Hid many cables underneath the mobo.

Results, not much better than before.





And while I'm at it, took this pic. <3 reflection.