Can a barton 2500+ run at 3200+@200FSB table for rendering 3D/else? and at what Vcore? I'm using Abit AN7 mobo.

how to know if it's a good stepping or not? Just rise theFSB to 200mhz?

My ram clock out at 338 T-T old ram, nvm, i think i just put FSB divider... to 333 thanks alot.

Help, I can't make my 2500+ oc to 3200!! It just hang on reboot.
I try to rise the FSB from 166 to 200 @1.685V but it won't work. Anyone any suggestion?

yup, nforce 2, just now try clocking increase by 5, clock out at 175, won't go any higher. my ram max out at 342, nonw i run only 290 i used 5/4

Ok, i try again. what is the optimum clock for 2500+? i need to run it long period coz need to render lot's of 3D (maya)

Oh man, my windows just crash!!! Once the clock gets over 1992Mhz, windows won't boot. Can anyone tell me what's going on? Your guys can OC so smoothly.... (sad)

This post has been edited by dennisdreams: Nov 12 2005, 09:15 PM

The Vcore now is 1.712, and I'm running at 12.0X166 with no problem. Computer can't boot into windows either on 12.5X166 or 11.0X175+ RAM I keep it lower then 333 already.

Ok, I'll try after running the SP2004 first on current state. let it run about 15 minutes. I'll post later on the progress, thanks a lot.

Failed...... Can't boot-up into bios either 12.0X174+ 11.0X174+ with both
FSB Spread Spectrum - Disabled
Enhance PCI Performance - Disabled
I think I'll just keep it at 12.0X166 for normal used first. Ask someone expert enough to check it out for me. Thanks guys for all the comment

Wow, 1.65 to 1.9!!! It's ok now, I think 2000Mhz is currently enough for my normal usage. Later try to OC again with my friends with experience. Thanks everyone.

I still uses my old Volcano 7+ now working on 46 idle, 52 full load.

IC, IC gotto save money for a better ram then. I'm thinking 2G DDr 500

lol ~~~~ What were you baking there? pizza? lol