Outline ·
[ Standard ] ·
Linear+
v7.0 The OFFICIAL 3G/5G Honda City 2011 thread, Theres more to the city than meets the i
Eclipse80
|
Dec 21 2012, 12:48 PM
|
Getting Started
|
Hey there guys. I'm having problem with my A/C switch. I can't switch it on (i.e. I can't press it). Which means I only get hot air blowing to my face!
But when I press & hold the A/C switch, the A/C is actually working (i.e. I get cold air).
Anyone else faced this problem.
|
|
|
|
DaBestOne
|
Dec 21 2012, 05:28 PM
|
|
QUOTE(Eclipse80 @ Dec 21 2012, 12:48 PM) Hey there guys. I'm having problem with my A/C switch. I can't switch it on (i.e. I can't press it). Which means I only get hot air blowing to my face! But when I press & hold the A/C switch, the A/C is actually working (i.e. I get cold air). Anyone else faced this problem. There is something problem on your A/C switch button, u can send to check at accessories shop and see
|
|
|
|
vuilun
|
Dec 21 2012, 07:52 PM
|
New Member
|
QUOTE(xin @ Dec 21 2012, 11:47 AM) does the side step you bough comes with the connector ? If it comes with the connector then it is plug and play to the MICU aka fuse box. 1> If your side step comes with the connector then unplug the green harness, plug in your side step plug and there should be another plug to plug the green harness. Basically its a plug and play. 2> If your side step doesnt comes with the connector. You should have 2 wires, 1 is postive and the other 1 is negative. Slot the wires as shown in the below pic. No need to cut the wires, just slide in the wires and secure it. [attachmentid=3218909] Thanks for the advise.. Mine is 2 wire only...means that all four plate also need extend the wire so it can reach to the fuse box? I don't think ori wire enough long to pull till fuse box... The picture shown fuse box is it under steering there? Just right behind the bonnet open switch?
|
|
|
|
TSearl-ku
|
Dec 21 2012, 10:07 PM
|
|
QUOTE(vuilun @ Dec 21 2012, 07:52 PM) Thanks for the advise.. Mine is 2 wire only...means that all four plate also need extend the wire so it can reach to the fuse box? I don't think ori wire enough long to pull till fuse box... The picture shown fuse box is it under steering there? Just right behind the bonnet open switch? good pic for guidance from Xin ... mine is not plug and play so i connect to the cabin light ... all four door will pull through and use the cabin lights power source
|
|
|
|
vuilun
|
Dec 21 2012, 10:27 PM
|
New Member
|
QUOTE(earl-ku @ Dec 21 2012, 10:07 PM) good pic for guidance from Xin ... mine is not plug and play so i connect to the cabin light ... all four door will pull through and use the cabin lights power source Where is the cabin light power source bro?
|
|
|
|
TSearl-ku
|
Dec 22 2012, 05:13 AM
|
|
QUOTE(vuilun @ Dec 21 2012, 10:27 PM) Where is the cabin light power source bro? oh that i dont know ... the dude at the accesory shop tested one by one and found it ... but i never took note of it This post has been edited by earl-ku: Dec 22 2012, 05:14 AM
|
|
|
|
vuilun
|
Dec 22 2012, 04:53 PM
|
New Member
|
Anyone know where to find the car colour code? Or any bros know 2012 fl city black colour..the colour code is what? Urgent help please
|
|
|
|
aarex
|
Dec 22 2012, 09:59 PM
|
|
QUOTE(vuilun @ Dec 22 2012, 04:53 PM) Anyone know where to find the car colour code? Or any bros know 2012 fl city black colour..the colour code is what? Urgent help please Crystal black pearl (code: NH731P)
|
|
|
|
vuilun
|
Dec 23 2012, 12:04 AM
|
New Member
|
QUOTE(aarex @ Dec 22 2012, 09:59 PM) Crystal black pearl (code: NH731P) Thank you bro
|
|
|
|
samwjy
|
Dec 23 2012, 10:41 AM
|
Getting Started
|
Hi guys, I am going to get a White City. Anyone has a white city with full set of modulo kit on with the modulo front grille? Can show me the photo of it? I'm planning to get one with the kits =) Is the Cheras Honda reliable?
What's the lowest interest rate I can get for loaning 80% of Honda City Grade E ? 2.43%?
This post has been edited by samwjy: Dec 23 2012, 10:43 AM
|
|
|
|
xin
|
Dec 23 2012, 12:32 PM
|
|
QUOTE(samwjy @ Dec 23 2012, 10:41 AM) Hi guys, I am going to get a White City. Anyone has a white city with full set of modulo kit on with the modulo front grille? Can show me the photo of it? I'm planning to get one with the kits =) Is the Cheras Honda reliable? What's the lowest interest rate I can get for loaning 80% of Honda City Grade E ? 2.43%? Added on December 23, 2012, 12:47 pmQUOTE(vuilun @ Dec 21 2012, 07:52 PM) Thanks for the advise.. Mine is 2 wire only...means that all four plate also need extend the wire so it can reach to the fuse box? I don't think ori wire enough long to pull till fuse box... The picture shown fuse box is it under steering there? Just right behind the bonnet open switch? It means that the seller only give your the side steps only, no extra lenght wire to be connected to ? If that is the case i think need to extend and wires, you can go to the acc shop and ask then to do the extend then slide in the connector if you dont want to cut or splice and wires. This post has been edited by xin: Dec 23 2012, 12:47 PM
|
|
|
|
j45on
|
Dec 23 2012, 04:59 PM
|
|
seriously, each time I look at the kits on the car I am tempted to get it.
|
|
|
|
Johnmak
|
Dec 23 2012, 05:06 PM
|
New Member
|
I know someone have Honda city white colour , maybe you can call the person 019-3605531
Added on December 23, 2012, 5:11 pmI know someone have Honda city white colour , maybe you can call him 019-3605531
This post has been edited by Johnmak: Dec 23 2012, 05:11 PM
|
|
|
|
samwjy
|
Dec 24 2012, 12:51 AM
|
Getting Started
|
Is there any drawback having the kits?
Also, will aftermarket ABS material kits have big difference from the original Modulo?
|
|
|
|
mytaffeta
|
Dec 24 2012, 03:28 AM
|
|
QUOTE(samwjy @ Dec 24 2012, 12:51 AM) Is there any drawback having the kits? Also, will aftermarket ABS material kits have big difference from the original Modulo? i would suggest u to get PP instead of ABS.. ABS will have a weird look for rear bodykit..
|
|
|
|
samwjy
|
Dec 24 2012, 07:17 AM
|
Getting Started
|
QUOTE(mytaffeta @ Dec 24 2012, 03:28 AM) i would suggest u to get PP instead of ABS.. ABS will have a weird look for rear bodykit.. What's the material given by Honda Malaysia? Ty
|
|
|
|
hollyfish
|
Dec 24 2012, 06:46 PM
|
Getting Started
|
QUOTE(samwjy @ Dec 24 2012, 07:17 AM) What's the material given by Honda Malaysia? Ty PP. Added on December 24, 2012, 6:49 pmQUOTE(mytaffeta @ Dec 24 2012, 03:28 AM) i would suggest u to get PP instead of ABS.. ABS will have a weird look for rear bodykit.. Mine is ABS, bought from accessories shop. No wonder it looks so "fat" at the back. Might change the whole rear bumper together with rear skirting next time. This post has been edited by hollyfish: Dec 24 2012, 06:53 PM
|
|
|
|
xin
|
Dec 26 2012, 11:43 AM
|
|
QUOTE(hollyfish @ Dec 24 2012, 06:46 PM) PP. Added on December 24, 2012, 6:49 pmMine is ABS, bought from accessories shop. No wonder it looks so "fat" at the back. Might change the whole rear bumper together with rear skirting next time. Then can change to the new FL rear bumper plus skirt d
|
|
|
|
forrest
|
Dec 26 2012, 02:45 PM
|
|
Anyone heard of Aorto pedal lock? Is it good?
|
|
|
|
xin
|
Dec 26 2012, 03:35 PM
|
|
QUOTE(forrest @ Dec 26 2012, 02:45 PM) Anyone heard of Aorto pedal lock? Is it good? From previous threads QUOTE(foocy2001 @ Feb 22 2009, 01:44 AM) Just something to share with all of you... Went to Klang to install a brake pedal lock today. Long story short, found exactly what I was looking for. It's called Aorto Lock and it's from Thailand. It uses a double lock system with triple locking mechanism. Comes with Y-splitter socket for disabling ignition (no wire cutting). Also comes with multi-color LED when lock is engaged to alert that the lock is ON. Got it for RM450. Thought this might interest some of you here. Sits neatly beneath the steering. You can see the double lock barrel here. The lever that you pull the lock falls back into place, so nothing juts out. The pedal lock is spring loaded, so it bounces back when unlock. This shows the LED when the lock is engaged.
|
|
|
|