Welcome Guest ( Log In | Register )

Bump Topic Topic Closed RSS Feed

Outline · [ Standard ] · Linear+

Unifi Official TM UniFi High Speed Broadbrand Thread V11, FREE Installation & 1-month subscription

views
     
kekura
post Jun 21 2011, 01:20 PM

Casual
***
Junior Member
322 posts

Joined: Jan 2003
QUOTE(MGM @ Jun 21 2011, 12:31 PM)
Just install Unifi VIP5 with all TM equipment. Request that they install 15m of RJ45 and RJ15 with raceway but gave the excuse they running out of stock but promise to come back so for the time being is using standard 1m cable and everything put together. Sign the acceptance form but put down a condition that they are suppose to install the 15m cable at a later time.

I have two notebooks NEW and OLD, the NEW one is able to detect and access wireless and wired
But the OLD one can access thru RJ45 wire and but cannot detect my own UNIFI wireless network even though it can detect many neighbourhood UNIFI networks. What could be the problem, pls help.
*
i have the same problem. it is a compatibility issue. My old PC can connect the wifi but the traffic is intermittent. i use RJ45 directly now can surf full speed without intermittent.

the only way to solve this issue is to replace with better quality router that can support unifi.
kekura
post Jul 22 2011, 03:25 PM

Casual
***
Junior Member
322 posts

Joined: Jan 2003
QUOTE(rushmode @ Jul 20 2011, 04:32 PM)
anyone has succes setup unifi in buffalo whr-hp-g54 with dd-wrt? can i have the screenshot of your setup please?

tried to follow rizvanrp instructions but still failed.
*
QUOTE(toytoy @ Jul 21 2011, 05:22 PM)
Hmm same experience here for iPad2. When i browse using WiFi it stays connected but after some time it will stop responding.

Have to off wifi and on back then only work. But after some time, it will hang again.

I changed to 20Mhz already.
*
last time i had problem with my unifi DIR 615 router and have shared my problem here. Now i dont have problem anymore and everything work superb. Previosly i got this:
1. ipad2 connection unstable. after a while it lost connection. had to wait for a while until connection restored or reset the wifi on ipad.
2. very low signal in my room (i stayed in apartment), connection pretty bad
3. my desktop just beside the router, using wireless G USB, got intermittent connection.

the members here advise to change to b/g, and also set using 20MHz only. have done it, but no significant improvement. finally this is what i did:

1. use back my old Buffalo GHR-G54S as AP, and set the DIR-615 as bridge. You'll need 'operator' password to configure the DIR-615 as bridge, not 'admin' (refer to rizanrp guides). The setting in Buffalo same as streamyx, just change PPPoE username/password.

Although the Buffalo is becoming obsolete in malaysia market, but it still performs great with DD-WRT. Now all my problems above are solved. The network is superb. Signal very stable. Never hang, never drop connection.

Asus RT-N56U will be my next replacement in the future.... brows.gif
kekura
post Jul 22 2011, 04:35 PM

Casual
***
Junior Member
322 posts

Joined: Jan 2003
QUOTE(rattan @ Jul 22 2011, 03:40 PM)
Happy to hear u manage to solve your wifi issues. SO using buffalo router now u cannot view IPTV. Am I correct ?
*
still can. the DIR-615 only bridge the internet traffic (via LAN port 3), not the IPTV traffic. The IPTV still go through the DIR-615 LAN port 4. By this way, the DIR-615 only focus on IPTV traffic control (i have disabled its wifi), while the Buffalo focus on the wireless/wired clients.

i have also tried the newer Buffalo WCR-GN (stock firmware) as a replacement to old WHR-G54S (DD-WRT firmware), but the WCR-GN performance still not that good even though with the N-wireless. I can get higher bandwidth speed for files transfer using the old router.

This post has been edited by kekura: Jul 22 2011, 04:40 PM

Topic ClosedOptions
 

Change to:
| Lo-Fi Version
0.0437sec    0.99    8 queries    GZIP Disabled
Time is now: 27th November 2025 - 07:31 AM