i alrdy bought wc component n do some stdy from google.

but i dont really know how to setup.

1st step,what should i do?

i dont have a casing yet.

i used EK pump,res,and cpu water block and gt 360 rad.

thnks bro !!



got another tip??

Might as well you pick up a case 1st, because the tube length and how you run the tubing will depend on what case you are using.

owh,ic..

dont forget to flush your rad before use. 1 mistake i did and regret it until now...

flush??why bro??

And I didn't flush mine....too excited and installed everything. But then I have took them apart countless time since the 1st day till now (about a month) due to reroute the tube, change fittings, and other little stuffs. I never reuse the water though, only the fresh one goes in the loop...should be ok ba kan?

becoz u never knew what inside your rad after they send it out from factory. just to be safe. coz mine got so many foreign objets

hahaha same like me... too excited.. well just to be safe .. but if u see got some particals in your res then i think u better flush laa.. since u already pasang the wc

I didn't flush mine either and I survived until today.

big boss no need to flush.. very rich.. just now also i give him money

ZZZZZzzzZZz, I've paid to the bank, bayar hutang kad kredit

i belum pasang lagi laa pump tuh.... tgk fikir camne nak route

Hmm...luckily my res looks clear inside. No unknown object floating inside. But nevermind, I will take everything apart again in couple weeks time when I swap my PC casing. Then, I will make sure I flush everything.

haha..ok bos.

wta sumthing,i dont know the flow of the water lorr.so how?

Flow of the water? You mean the flow direction? I have mine setup from Res -> Pump -> CPU -> Rad -> Back to Res. Will resetup when I put the GPU to the loop in couple weeks time.

owh,i use mobo waterblock,the flow direction Res -> Pump -> CPU ->Mobo-> Rad -> Back to Res.is that correct?

flow doesnt matter as long as your res before pump

owh,thnks for ur help..

we are all in the learning process