Nov 9 2014, 09:41 PM
may i know how you configure the #ont/system/shell to gain access to the web interface?
I tried append rule 80 in the iptables. Then save it with "iptables-save". I don't know what is the command to reload iptables. If i reboot the configuration is lost.
Would you mind provide detail step by step instructions on how you enable the web interface.
Thank you in advance.
QUOTE(warlove3 @ Dec 16 2013, 04:42 PM)
Manually configure your network adapter to 192.168.1.xxx
Then
Access using SSH via PuTTy (BTU IP : 192.168.1.251)
Username : root
Password : admin
then on the ONT> page
type enable and press enter
which makes it look like this
ONT#
then you type help for more commands
ONT#help
from here you can proceed to do your settings as I'm not very sure about the settings would end up killing my configuration on the router
I can able to open the Web interface but i couldn't get through cause I do not know the password, or it must be configured in the terminal before logging in to the router, good luck with it
Then
Access using SSH via PuTTy (BTU IP : 192.168.1.251)
Username : root
Password : admin
then on the ONT> page
type enable and press enter
which makes it look like this
ONT#
then you type help for more commands
ONT#help
from here you can proceed to do your settings as I'm not very sure about the settings would end up killing my configuration on the router
I can able to open the Web interface but i couldn't get through cause I do not know the password, or it must be configured in the terminal before logging in to the router, good luck with it
Quote
0.0138sec
0.27
6 queries
GZIP Disabled