Need advice from u all, few days ago i buy a monoblock tat have 3 band adjustment only: level adj and 2 tone...

when it install to my dvc woofer , the bass come out too hard, but i want it to be more softer, so the problem is the amp or i need a preamp to set the woofer softer?

have try to adjust on my HU , the problem still exist....hope can get help from u all...

PS: the monoblock is u dimension ,hope somebody can help me to tune it perfectly...
And 1 more question, if i finally decide to install a 7 band preamp, does it really can help to change the hard bass to softer bass or it just wasting money only,better change amp or woofer or HU?

This post has been edited by vikice: May 11 2011, 12:50 PM

lower down the level adjustment knob? and what are the 2tone for? bass and treble?

i oso got monoblock amp too ! my current setup is x-over 50' , gain knob 60' , remote bass switch 60' .

---

Added on May 11, 2011, 12:17 pmif pre-amp is only 7 band has sub-woofer freq control selection ! otherwise 4 band or 5 band pre-amp don't have these funtion ! just my opinion .....

*ps: lpf more high hit hard bass , like here all sifu recommend below 60' till 50' freq is the best range but sometime need gain a bit volume ....

This post has been edited by iciwe: May 11 2011, 12:17 PM

i've tried to adjust the level adjustment, but seem like that one is the volume... i also don know what the 2 tone for because the monoblock just state tone for the 2 band there...hope sifus here can tell me what they are because i've tried to adjust them but didn't notice the changes...

---

Added on May 11, 2011, 12:42 pmdo u mean that the 2 band of tone of my amp is lpf and hpf?coz i cannot any other adjustment key except those 3 ...my current setup is gain knob 80, remote 100,hu bass level -8...lpf is for hard bass, and hpf is for?


This post has been edited by vikice: May 11 2011, 12:42 PM

why dont u just lower the gain level on the amp..?

oic..... try reduce remote 100' to 50'/60' will differ alot .... between Hpf/Lpf is Hpf = cut deep bass (protect ur 6.5" speaker life spam) while Lpf = cut all music and vokal ... (remain bass sound only)

lower the gain level will decrease the volume, the things tat i want is loud bass but more softer, just like u tune up the subs freq in the preamp, is like more vibration(trembling)and loud, not just bangbangbang without the vibration( i don like solid or hard one)....

---

Added on May 11, 2011, 9:29 pmlearn alot from u, thx alot...

This post has been edited by vikice: May 11 2011, 09:34 PM

I think the culprit may be the size of your enclosure.
Ported or sealed?? Size??

Mind to elaborate what you mean by 'hard' and 'soft' type of bass?