volume full @ 60?
Edifier Speaker/Headphone Fan Club V6, Come & Join Our May 2013 Contest! :)
|
|
 May 5 2011, 01:14 AM
Return to original view | Post
#1
|
 
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A   
|
|
Quote|
|
|
|
|
May 5 2011, 08:44 AM
Return to original view | Post
#2
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
QUOTE(infernoaswen @ May 5 2011, 06:09 AM) yup.... I would go deaf if I put anything above 33.  but for a while only la...scared later speaker rosak....hahaha  QUOTE(bulibulizaimon @ May 5 2011, 07:24 AM) Still waiting for any Edifier C3 owner to mod their sub, change to 4ohm driver better change to S530  |
|
|
May 10 2011, 02:38 AM
Return to original view | Post
#3
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
Just plug in the new cable from "ssyycc". It does makes the treble sounds sharper and soundstage wider as I could hear some instrument behind also not to mentioned the bass is somewhat, punchier. Does letting it playing/burn in for like 100hours make changes to the sound anymore?
|
|
|
Mar 1 2012, 12:20 AM
Return to original view | Post
#4
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
Anyone know roughly how much does Inter-asia charge to repair PCB problems of C3 speaker? Worth getting it repair?
|
|
|
Mar 1 2012, 07:44 PM
Return to original view | Post
#5
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
QUOTE(power911 @ Mar 1 2012, 10:53 AM) still cheaper than buying a new C3 They replied cost around 150 to replace the PCB. Worth it? or I should get a new speaker instead? unless you had to deliver it via postal... but still cheaper Added on March 1, 2012, 10:56 am 3 slots is enough. green normally for front l/r, red normally for rear l/r and blue normally for center/sub  |
|
|
Mar 2 2012, 01:35 AM
Return to original view | Post
#6
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
QUOTE(power911 @ Mar 1 2012, 09:15 PM) repair it... just send the amp will do Instead of sending it to Inter-Asia just to replace the PCB, is there anyone out there can replace those caps too? beggarmaster, where are you?  QUOTE(IwanAGP @ Mar 1 2012, 10:40 PM) Or see if anyone selling the very same AMP, 2nd hand out there I dont think can get, speaker hardly spoils, no?  |
|
|
Mar 5 2012, 02:25 PM
Return to original view | Post
#7
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
Called Inter-asia about the PCB board and they say need to wait for next shipment which falls on another month.. Quite disappointed.
|
|
|
Mar 23 2012, 02:39 PM
Return to original view | Post
#8
|
|
Senior Member
3,910 posts Joined: Jun 2005 From: Andy @ London.com Status: N/A
|
Can recommend how does C3 compares with Edifier R1600T or edifier 2.0 speaker? Should repair the C3 or get a new set directly?
|
|
Topic ClosedOptions
|
| Change to: |  0.0328sec
 0.25
 7 queries
 GZIP Disabled
Time is now: 3rd December 2025 - 10:13 AM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.