Recommend JL 10 or 12w3v3. should be less than 1.5k. Very very SQ with kick.

I you can find KFC you wont miss the place.
If you're looking to audit Scans level drivers, you wont be disappointed.

All exaggeration i assure you.

Like this la.

Tomoro night 11pm onwards 16/7 TT at Subang Jaya.
All are welcomed. Just tok kok, listen to diff systems, friendly yamcha session, even if you have nothing but stock but are interested to start a simple system, good place to source for info.
PM me for details.

This post has been edited by krayden: Jul 15 2011, 11:16 PM

Ok i guess 10 also can.

So dang hard to please your golden ears mang................
lol.......

---

Added on July 20, 2011, 9:11 pmMy staging fail kao kao.

This post has been edited by krayden: Jul 20 2011, 09:11 PM

which class d is this?

Currently saving up to mod the driver seat and steering wheel to the centre, like Mclaren F1. lol

Lotsa ICERs think about this when nothing to do lol.

better save the 300-400 till reach 700 then change component speakers.

Front stock speakers move to the rear, buy new components for the front.

@nameless: try morel maximo rm700ish.

For front component speakers and 1 sub:
4ch amp is the easiest and cheapest
2ch for front and mono for sub gives the best performance

2ch + mono is about the same price of 4ch or close.
But 4ch amp means you'll need only one line of power cables, no need distribution block, and if the amp supports it, only 1 pair of RCA cable. Definitely makes more sense than 2ch + 2ch.

A mono will however outperform any bridged ch of the same level in terms of SQ.

So the choice is yours, convenience (4ch) or performance (2ch + mono) or budget (2ch + 2ch).

Ulti setup, AB class mono for each speaker. 2way + sub = 5biji mono.

Wrong.
No point getting 2ch + 2ch.
Just get 1 biji 4ch OR 2ch + mono.

Under seat or trunk is up to you.
Underseat cheaper due to shorter cables.
Trunk will look the best if you do a full amp rack + sub in the wheel well (expensive).

Another thing, 4 gauge power cables or thicker please (lower number is thicker).

I suggest you use 4ga between dist block and amps too. All short lenghts, about 1m to each amp, so the price diff from 8ga is not much. This way you will never need to upgrade these power cables in the future. Even a high powered amp upgrade also np. Dun forget to use 4ga for grounding too.

Your car so powderful, the dyno sure burn 1. Have fun.