um i need help. i oced my e8200 from 333*8 to 341*8. my problem is that i cant go any higher than 341 or the black screen of death will appear. i am using maximus formula and ocz ddr2 800. new at oc-ing here

er... i just need to know what to do. i am pushing it at stock volt but dunno y stuck there. i suspect the rams. but i dunno what to do with the rams.

oh i see. i will try it. see whether can go any higher.

---

Added on May 5, 2008, 3:46 pmjust to tell u guys, i am now running at 450*8= 3600MHz for cpu and 5-5-5-15
450MHz for the single channel 1GB rams all at stock voltage. now i am oc-ing my cpu to 3.0GHz and 400MHz 5-5-5-15 for rams how do i make the timing tight??? must i alter the voltage first or change the timing first??

This post has been edited by glock88: May 5 2008, 07:41 PM

lol stuck sensors. i think my e8200 sensors stuck too.. nvr below 40... it is safe to turn of the thermal throttle TM1 and TM2 for proc. coz i kinda findit hard to stress my e8200 at 4Ghz.. 500*8 everytime stress 2 seconds only error in 1 core but the other can continue.

hmmm its funny coz 500*8 1.38V ( kinda high) only will get error... core temp could go up to 6X+++.. anyways to get a stabler setting?

using maximus formula... yea maybe gtl and vtt... but i am not so sure in setting them... lol so kinda pick 1 and try my luck.. haha my northbridge is at 1.62v anyways.

yea... i am sure... hehe yea... when running 500mhz NB core is around 50 degrees ad... lol. its unstable when around 1.3-1.4, i think