Flow Rate Impact in Water Cooling
source: ocforums.com
Discussion about watercooling and the results, Version 2
|
|
 Mar 2 2009, 10:50 AM
Return to original view | Post
#1
|
 
Senior Member
558 posts Joined: Jun 2006 From: KL Sentral - Segamat   
|
|
Quote|
|
|
|
|
Mar 9 2009, 07:48 PM
Return to original view | Post
#2
|
|
Senior Member
558 posts Joined: Jun 2006 From: KL Sentral - Segamat
|
QUOTE(Evil Oracle @ Mar 5 2009, 02:57 AM) i fan or temp?just bought coolit eliminator.. but da performance y not stable sometimes very low sometimes got lilte bit high but still ok..  |
|
|
May 5 2009, 02:41 PM
Return to original view | Post
#3
|
|
Senior Member
558 posts Joined: Jun 2006 From: KL Sentral - Segamat
|
3000 is excluding tax....IMO
better check on the taxes bro |
|
|
May 8 2009, 10:57 PM
Return to original view | Post
#4
|
|
Senior Member
558 posts Joined: Jun 2006 From: KL Sentral - Segamat
|
ive seen people who use 7/16' without barbs
is it safe? |
|
|
May 9 2009, 02:15 AM
Return to original view | Post
#5
|
|
Senior Member
558 posts Joined: Jun 2006 From: KL Sentral - Segamat
|
QUOTE(lichyetan @ May 8 2009, 11:19 PM) clamps bro, if used w/o barbs how to mount the tubings ? i been one of those who didnt use clamp at 7/16 tubings, its basically tight enough, but cons for 7/16 is a headache when setting up and removing tubings. thank you for the correction  This post has been edited by dro: May 9 2009, 02:18 AM |
|
|
May 26 2009, 01:03 AM
Return to original view | Post
#6
|
|
Senior Member
558 posts Joined: Jun 2006 From: KL Sentral - Segamat
|
i would focus on heat dissipation i guess
|
| Change to: |  0.0441sec
 0.78
 7 queries
 GZIP Disabled
Time is now: 9th December 2025 - 09:37 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.