Using *ahem* version?

Your installation of Papago X5 is not complete. There are quite a number of folders/sub folders which define the screen resolution. See if you have them.

I always stuck on Odin "Do not turn off Target" steps... Tried 2 firmwares still the same.... anyone help? 

now wat fw are u on?n wat u wan to go?

Same case with mine yesterday night...what a tragedy night...
Anyway i managed to flashed it with the help from sifu here~ 

1st, ur source of DXJG4 might corrupted...kindly get it from the link given on 1st page.
2nd, pit 513 recommended to flash DXJG4 with re-partition.

You guys r right! with the download mode in GS...it seems difficult to brick the phone XD

It look like ur CSC files got problem.

try download the whole fw from the 1st thread, as the samfirmware one is corrupted. U are right to ue PIT 512.

It definitely got different, otherwise, it wont call 512 and 513, but what the different, i do not know.

According to Samfirmware, recommended to use 512. So far samfirmware pretty reliable. I think most Eclair use 512.

you flash with all the pda,csc and modem files? i'm not sure will this cause this problem or not.
if you using the version that download form 1st page, all you need is only the code file will do(something like CODE_I9000DXJG4.tar).
i only flash with CODE_I9000DXJG4.tar
Hope this help...

Guys... would like to ask something about Doc Froyo...

I would like to use update.zip to launch ClockWorkMod to install Doc Froyo..
Will this method make any changes to my recovery(2e)?
Can I use this method from DZJP2 firmware?

Ok.. if u use the update.zip, from recovery 2e, it will change ur recovery 2e to CWM, shd u wanna revert to the stock 2e, there is option from the CWM.

Subsequently, u just have to follow the instruction to install the particular fw that u want
Wait... u can't even get into ur phone, how are u going to copy the update.zip file into ur sdcard?

oic...

once u in 2e, just follow the step by steps from DOC's ROM froyo... every easy and clear.

Have to apply twice.

like this

Off phone, boot into recovery2e

Apply update.zip

then phone will reboot

choose apply update.zip again

then it will become CWM

Do factory reset & wipe cache then go into advance feature to do dalvik wipe. Reboot.

i face it once, just reboot then ok d

The latest update of LaucherPro is sucking battery big time. Ver 0.8.1.1
I check & monitor and found that it is using CPU power alot..

It was fine previously, only using 2% of full charge before now.

Now, I find that it is using 15% of my full charge

i'm using 8.1.1 as well.
Doc's 7.6.1 rom, batter drain fast, fully charge 100%, after less than 1 hour, drop to 96% 95%