for ur guys information, i jus buy a corsair cm2x1024-8500c5d ram
my mb cant boot up when i put both of the ram !
first of all, my mb is msi p45 noe 3.
it works perfectly when i'm using 677 ram.
after i buy the 1066 mhz ram i cant boot my mb on 2 rams.
i had seen many forum say tat need to be overclock it to 2.1v and 5-5-5-5-15
so i dono anything on overclocking.
can any pro overlocker teach me how to solve this problem??
please!!! i'm quite nervous about it.........

thank you all after read my tread, and hope u guys can provide me a solutions...........


This post has been edited by sakuraxxx16: Oct 22 2010, 02:10 AM

but the product spec says can support
http://www.msi.com/index.php?func=prodmbsp...o=&prod_no=1611
haiz......... bad luck for me....... any 1 can help????

no... both of the ram actually works..
but after i put both of them on slot. my mb cant boot up.
i try to put it 1 ram and it works perfectly and switch the ram also same.
the only problem is when i put both of them in two slot it cant works.
should i update the latest bios ??

---

Added on October 21, 2010, 11:44 amhttp://www.msi.com/uploads/test_report/TR10_1611.pdf
and the msi forum says can support based on test result

This post has been edited by sakuraxxx16: Oct 21 2010, 11:44 AM

haiz... den i'll try update my bios tonight.
my ram is 1 gb + 1 gb on 1066 mhz.
if i put 1 ram, the clock will be in 1067 on bios. stock v is 2.1 but i set auto at bios.
but i'm just not familiar wif overclock, so i dono how to set the latency to 5-5-5-5-15.
any 1 can teach ?

oic... can teach me wat steps tat need to care for when flash bios??

and... can give me any website or forum to teach overclocking ??
based on picture or video?
thx....

ya....
but i had already solve the problem!!
guess?? i just reset the cmos and run it........
hahahhaha......... it works without flash bios!!
thank you all for the help!!!