but wait, turboV is just for your mobo? or my x58 can use also? i've been wanting to increase my cpu speed to 3.6ghz, but im scared i'll bust my cpu.

Depends on what BSOD u got.
A bump on vcore, vdimm or lower VTT might help. 1.3x VTT is sufficient for that uncore.
Might try to play with PCIE 105Mhz, IOH 1.175v etc... ahh LinX failure could be many reasons.
Run memtest to check dram error, but for R3E I just let it auto except for the 9-9-9-x

---

Added on January 6, 2011, 12:01 am
Nice try bro. U need to manually adjust vcore more than the current 1.15v, say 1.3v should be sweet for 3.8Ghz
vdimm set to 1.65v 1st, after this u might adjust lower for the most optimized one, say 1.6v.
QPI/RAM aka VTT set to 1.3x, for that uncore should be enough.

Either 2:8 or 2:10 for BCLK:Ram

Let's say for 2:8 (or 1:4) default BCLK of 950 is 133Mhz
So 133:133mhzx4 is 133:533mhz effective dram freq for DDR3 is 533x2=1066mhz
U may say 133x8 ~1066mhz for 2:8
For 2:10, effective dram speed is 133x10 = 1333mhz
Hope this helps. 

Guys izzit ok if i oced i7 950 to run 4.2 24 hours with CM 212+ only?

So what temp is consider ok/safe?

@gn9746203

post screenshot of ur bios setting .
we can't help u unless we see the setting .

@owikh84

bro, at 4.6 what's ur temp reading on vrm and cpu ?

The turbo boost, C3,C1 state all disabled already?

possible its ur ram unstable .

btw, y ur running ur ram too low but with high voltage ?
try lower the ram voltage .

and try exactly double frequency for ur uncore .

We had to run 1.66 volts for stable performance even at low RAM clock speeds. QPI also needed to be nudged up to 1.3 volts.

u can get it boot doesnt mean its stable .
intel said a lot of thing .
i think u better refer to 1st page and see how's d setting on owikh84 rig .
dat shud give u basic idea on the scaling of x58 platform

Something wrong with ur ram settings I can it's running single channel. Curious how do u put ur ram on ram slots?
from CPU socket slot A-B-C-D-E-F, dual channel is B+D for ur case.
btw, what a waste 1366 running dual channel when the most interesting part of this platform is its triple.

Advise to do dual channel at slot B+D. Hmm what a waste running single channel on x58, it's even worse than old 775s.