Going to overclock my 930 soon. Thinking of the following combination for watercooling:

EK Supreme HF
XSPC RX 240 (my current case is CM690)
Laing D5

Don't think I'm buying reservoir. Budget kinda tight. Is the reservoir needed? Won't be cooling gpu yet, so this will just be the loop.

What you guys think?

Or maybe to keep things in budget I should get a cheaper pump and a reservoir? But getting a cheaper pump will mean compromising quite a lot in cooling performance I think.

Is the D5 too strong for a single loop for cpu only?

I'm currently using Kingston HyperX 6Gb 2000mhz but not overclocking my pc till I get my watercooling.

Feel like tightening the ram timings but dont know which values I should adjust and what values I should adjust them to.

What do you guys think about my water cooling set up?
http://forum.lowyat.net/topic/1615410

Just installed my water cooling loop and I'm beginning my overclocking! Wish me luck!

---

Added on October 30, 2010, 2:13 amI followed settings from http://www.overclock.net/intel-motherboard...tml#post8435147

And am currently Priming at 4Ghz. So far temps are (60,56,56,54) highest after 1 hour.

Think I want to try pushing to more. I still have room for temp right?

This post has been edited by cheesycake: Oct 30 2010, 02:13 AM

Currently just finished Priming 4.6Ghz. One of the cores had an error after 3 hours,60 tests. The others worked fine for 12 hours total. I have already increased cpu voltage 2 notches since the last similar error. Currently cpu voltage is at 1.41v and qpi is at 1.25v. Any ideas on what should I do?