Got check your HSF? BTW, use RealTemp instead of CoreTemp

2.3vcore?    
i think it's 2.3vdimm right?
anyway,there might be one stick of them is a bit faulty,try to swap the ram slot.
if the problem still there,u have to test the ram with only one stick and run them in 1066 speed.
good luck in trying

omg.. what will happen then? i try it for 5 min.. and the temp fly up to 60 within 5 sec and maintain there.. after 5 min,it bcome 62.. i dont know what will happen if 24 hours.. 

anyway,thanks bro for letting me know 

easier to oc? or higher ghz push? or cheaper compared to 8400?

not bad hengmy..btw try prime priority 8

ran a test early this morning on my E8500 E0 at 4Ghz...still running...so far, so good...gonna use this for 24/7 setting...vcore at bios is 1.30v..temp is a bit high but i think still in the green zone.
is it ok for a E8500 E0 with that speed at that vcore?
*****updated*******
done 8hrs of orthos...

will try that later...i've just pumped in 1.3v and run the test ...so urs is at 1.26v rite..izzit bios or vdrop/vdroop?

i second that on the GTL Ref...after finding the sweet spot of my GTL (i meant the mobo one, not my GeniTaL  ), i can run my E8500 at 4Ghz wif 1.256v...the vid is 1.25v; so, quite happy with it.

if not mistaken, only the CPU: CPU1/3 : 62 and CPU0/2 : 60

dude ure proc is unstable dude...go and see ure linpack..
and run in diagnostic mode so can test all of ure rams to atleast 95percent physical mem..
for 2gb kit

no idea y u so happy with that fact..

so far tested min needed to test linpack 64 is around 1.7gbto 1.8gb... to ensure stability.. for vcore..

---

Added on October 31, 2008, 12:40 ambtw i have tested the tjmax for e8600 E0 on linpack..
its 95C..

once u touch that temp.. shutdown..
tested for 20 mins..

welll..nice oc there

Nice oc for stock vcore, push the proc bro see how high it can do

@h3ng,try 500x8 and see

Bro u volt 1.6? 

Depends on your budget too because quad core is more expensive compared to duallies.

E0 overclock better as it runs cooler.
It doesnt matter for me as I dont overclock like crazy...

Any E8xxx should be able to reach 3.8GHz easily without changing Vcore. Mine does 3.8GHz with a flip of the FSB to 400. Just change the stock heatsink to those old type P4 cooler and full load at 79C.

i heard E0 is good for overclocking ability but in game performance, the C0 owning E0..i wanna buy 1333Mhz FSB for overclocking only -___-" but right now i got rm1000 for MSI P45 Neo2-FR and proc..proc i think i will find E8200 OEM/used because i bugdet rm350 only..then another rm150 wanna buy ram 2GB for my bro pc -___-" haih..cost matter now..