They're still trying to get my unifi connected since today 2pm already. Something wrong with the auth server i think. haih...

Yup i had this less then 24 hrs after installation. by next day the router did this few times every min until it just unable to start anymore. so TM came next day replace

@rizvanrp
Bro, mind to share how you create VLAN?
I search through DD-WRT, I only manage to create 0-15 vlan.

Any idea?

-pWs-

my unifi vip5 is down since yesterday....dunno why...router and BTU is on, only LAN and wireless light don't come out...call customer service, for 10 minutes nobody take my call...

Hi izvanrp,
Hope you can help us to explain how to configure the following section:
Basic Setup
Advanced Routing
Networking


Thanks in advance!

I don't mind at all. It's good to have more OpenWRT users .

EDIT: By the way, why are you guys trying to set up VLAN? For isolation purposes? Or to set a few devices to have the same ip without conflict?
EDIT2: Looks like you guys are trying to get IPTV to work.


http://www.dd-wrt.com/wiki/index.php/Setti...ireless_traffic

If the guide does not work, ssh into the router using putty (username is root, pass.. is your pass), key in "ifconfig" (without '') and post the output here.

This post has been edited by blindbox: Jul 31 2010, 08:29 PM

just now i go 1U TM road show..that unifi ppl say unifi will be cap after august...shit..TM SUcks...

So ? Let them start capping

As long they dont touch our local p2p network , we are good to go

Ok, will go through & test first, will report & seek your expert advice later if still can't get it work
Actually my UniFi will be installed next few days, I was trying to seek some help & info here hoping to setup my Buffalo router with dd-wrt to replace TM's DIR-615.
So far still no clue yet, especially on those advance network setting VLAN stuff & how to get the IPTV works ...

Sigh, my 20MB unifi installation is not successful. Signal too weak
Looks like I have to use my streamyx longer.

Sorry may I know what do you mean by "Signal too weak"?
How does it happen? You mean TM can't do anything??

Hey tak boley bayar bill Unifi online?
TM belum create bill account utk Unifi ?

They'll make another appointment with me, this time with their network team to see can fix the DB box. Currently the DB box (green dustbin) has 24.8DB, which is NOT GOOD.

Hah.. looks like we both will get our VIP20 on the same day. I just hope I don't have to mess around with my home network's setup to get this thing installed.

Me too. I wish to use my Linksys WRT160N DDWRT to replace the DLink.
But it seems like nobody success to do it yet.

-pWs-

Pulled these old screenshots from May 2010




vlan2 in these screenies refer to the physical WAN port on the router but its different for each chipset. Yours may be eth0/eth1/vlan1 so you'll have to test it and figure it out. After you've done this properly, your router should be able to establish the PPPoE connection with a direct link to the GPON/VDSL unit.

This post has been edited by rizvanrp: Aug 1 2010, 12:05 AM

@rizvanrp,

Since you can use the DD-WRT route the VLAN properly with out the IPTV which is Tag as VLAN 600, can we do the following:

1. Setup the DD-WRT router to dial the PPPoE and route VLAN 500 to it's Lan Port after connect the WAN port direct to the GPON unit.

2. Disable the VLAN 500 and PPPoE dialer in the TM's DIR615 G1 router but leave the VLAN 600 setting. Plug direct to the GPON unit to bridge the VLAN 600 IPTV traffic to the STB.

Is this possible??

Might be possible.. I've tested this before but I don't really remember. If I'm not mistaken the GPON unit 'locks' each ethernet port the moment you plug a cable into it. So even if you're only using VLAN500 on the GPON units LAN port 1, you can't plug a second device into LAN port 2 of the unit that only uses VLAN600.

What I'm sure you can do however is plug a normal, cheap non-VLAN aware switch into the GPON units LAN port and wire your DIR-615 and DDWRT router into the other ports on that switch. A lot of devices tho :3 Might as well use a single VLAN aware switch?

Hi rizvanrp,
Thanks for the information sharing, will use it to configure & report here soon!

I was told by AlphaWolf on another topic to suggest Broadcom base router:
http://forum.lowyat.net/index.php?act=ST&f...0#entry35317179
could this be the reason why IPTV doesn't work on RaLink or Antheros?

Probably, I've only tested it only an RaLink based chipset (the TM DIR-615) so I've never said that IPTV would not work with dd-wrt in general. The only problem I had was that the RaLink router did not support port based VLANs.. if a broadcom router with dd-wrt will give you access to that it should work fine.