pmed

COD with Eric for twice.

Firstly COD for Voltage stabilizer. Frankly say, I did not feel any difference except lower idling rpm. Before was 1300rpm, after installing VS was 1200rpm.

Secondly COD for GC. Eric fixed 4 cables on my Corolla LE. Now this time can feel the difference liao. After igniting the engine and turning on the air-cond, rpm didn't "dip" as previously. Idling rpm became even lower. Just now I mentioned 1200rpm, now is 1000rpm. Second noticeable improvement is the tappet noise during cold start-up went off very quickly. Previously the noise took 1 - 2 minutes to go off, now only takes 10 seconds. I suppose the engine oil pump has got sufficient power therefore the cylinders get lubricated in shorter time. Other improvement is more responsive throttle. (Not sure if it's placebo effect)

hey bro thanks for your feedback. good that the result turns out as what I have told you.

vs has a negative cable needs to connected properly to your car electrical circuit. in old car, the ori ground cable connected to battery and body is old and very high resistance, thus vs current hardly traverse out quickly. so by adding good and new gc the connection is now more perfect vs found its path to start working.

nevertheless, gc installed will also improve electrical flow to supply enough current to your pump, etc equipments.

Hey, this morning started the engine, the noise has totally disappeared !

haha the clogs has just been cleared ?

Now I feel like installing a pair of Hella spot light. You got any advice for me? Any precaution during installation?

The negative of the connection install to body ( best to touch together with the ground cable point).

The positive connection, make a relay from battery positive terminal. Others follow the instruction guide.

sounds complicated to me.
I'll inform the installer about this.

Well, any question please contact me.

Usually ppl turn on spotlight together with high beam ?
I would like to put a toggle switch in dashboard so that I can turn on whenever I like. Is it feasible/possible ?

Yes this could be done by using a switch in cabin to control the relay which in then power up the lights.

PM me for the honda city 09. Thank you.

bro pm me price

hi, can PM me GC price fr myvi 1.5 incl installation..fyi, i already have ur VS installed..

tq

Price for wira Thx

Eric : Tried calling you but I assume you're overseas. Not sure if u got my sms. Kindly call me back as I want you to ground my car .


Elton

eh didnt know you also going for this, for the perdana i assume?

correct. He's a good guy

Pm me best price for myvi 1.5 thanks

Hi, Eric.

I have using your GC on my myvi and it improve my ride. Now, I decide to put it on my Toyota altis 1.8E 2008. May I know the price and do you have the setting for this model?