Welcome Guest ( Log In | Register )

15 Pages « < 11 12 13 14 15 >Bottom

Outline · [ Standard ] · Linear+

Performance Parts [WTS] Custom made grounding cable, Thick and performance Guaranteed

views
     
TSerictioh
post Jul 29 2012, 11:22 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


All pmed..
TSerictioh
post Jul 30 2012, 12:08 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(ayzprella @ Jul 30 2012, 10:35 AM)
bro, normally for Satria engine, how long do i need ? the stock ones looks to thin and car already have a repaint job. Please advice.
*
pmed
TSerictioh
post Aug 22 2012, 11:20 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


All replied
TSerictioh
post Sep 4 2012, 11:00 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(ZeLeecher @ Sep 2 2012, 08:58 AM)
Just a quick feedback after installing GC + VS. Was done during raya.
Vehicle: Proton Persona b-line Auto

Persona stock grounding really sucks. After installation:
- dimming of headlights barely noticeable during idle
- gear shifting much more smoother
- throttle much more responsive (response time about halved)
- makes the vehicle much more nicer to drive, can really feel the zippyness of the vehicle

Fuel consumption:
- no big change (consumption dropped by 0.4 l/km)
- since  responsiveness increased, need to be more gentle on throttle
- for those whose FC increase, it is most probably due to 'the foot' on the throttle
*
Thank you, any question in future remember ring me up thumbup.gif
TSerictioh
post Sep 7 2012, 05:12 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(kent05 @ Sep 7 2012, 04:00 PM)
hi Eric, can u explain this....http://forum.lowyat.net/topic/1849324
*
It's already in my VS 1st post for sometime.
TSerictioh
post Sep 22 2012, 09:40 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(PezOus @ Sep 22 2012, 05:01 PM)
Bro, how much for Chevrolet Optra 1.8. TQ
*
pmed.
TSerictioh
post Sep 25 2012, 10:49 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


All pmed..
TSerictioh
post Sep 25 2012, 06:12 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(1cx @ Sep 25 2012, 03:43 PM)
eric,
        please quote best price for serena C24 year 2006, loking forward for cod in puchong. please pm me.
*
pmed.. thumbup.gif
TSerictioh
post Sep 27 2012, 11:17 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(xxhuaxx @ Sep 25 2012, 06:59 PM)
Pm best price for wira use + postage fee thx Q
*
QUOTE(bladekiller @ Sep 25 2012, 07:56 PM)
bro, still rmb me? wonder if u did save your GC cable measurement for my car last time. PM me tks
*
pmed..
TSerictioh
post Sep 28 2012, 10:57 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(Mspot @ Sep 27 2012, 05:20 PM)
Eric, how much for Civic FD2's GC? and installation cost? tq
*
pmed..

QUOTE(andyaikau @ Sep 27 2012, 09:08 PM)
pm me price for gen 2. is it includw installation?
*
pmed..
TSerictioh
post Oct 1 2012, 05:48 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(Andzriana @ Sep 30 2012, 04:38 PM)
pm for kancil 850
*
pmed.

QUOTE(Mspot @ Sep 30 2012, 10:24 PM)
COD with seller today. Good service, responsible person. Took the time to explain what he does, and provides a 'before' and 'after' electrical measurements (This is probably his SOP).

I have not the time to review the differences in detail, but I immediately felt the car was 'lighter'. Had my car for 3 years. The car suddenly felt foreign to me, like the character of the car has changed. Almost afraid to speed. Almost.

Overall a value for money product. Thanks for the installation.
*
Thanks bro.... thumbup.gif

QUOTE(nhisham @ Sep 30 2012, 11:32 PM)
pm me for civic fd 2.0... with & without installation
*
pmed.
TSerictioh
post Oct 1 2012, 11:36 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(felixyukito @ Oct 1 2012, 06:05 PM)
Bro pm me prize for Myvi 1.3 old version, both COD and postage price
*
pmed
TSerictioh
post Oct 2 2012, 09:57 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(chemistry @ Oct 2 2012, 01:53 AM)
COD with Eric for twice.

Firstly COD for Voltage stabilizer. Frankly say, I did not feel any difference except lower idling rpm. Before was 1300rpm, after installing VS was 1200rpm.

Secondly COD for GC. Eric fixed 4 cables on my Corolla LE. Now this time can feel the difference liao. After igniting the engine and turning on the air-cond, rpm didn't "dip" as previously. Idling rpm became even lower. Just now I mentioned 1200rpm, now is 1000rpm. Second noticeable improvement is the tappet noise during cold start-up went off very quickly. Previously the noise took 1 - 2 minutes to go off, now only takes 10 seconds. I suppose the engine oil pump has got sufficient power therefore the cylinders get lubricated in shorter time. Other improvement is more responsive throttle. (Not sure if it's placebo effect)
*
hey bro thanks for your feedback. good that the result turns out as what I have told you. smile.gif

vs has a negative cable needs to connected properly to your car electrical circuit. in old car, the ori ground cable connected to battery and body is old and very high resistance, thus vs current hardly traverse out quickly. so by adding good and new gc the connection is now more perfect vs found its path to start working.

nevertheless, gc installed will also improve electrical flow to supply enough current to your pump, etc equipments.
TSerictioh
post Oct 2 2012, 11:26 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(chemistry @ Oct 2 2012, 10:25 AM)
Hey, this morning started the engine, the noise has totally disappeared !
thumbup.gif  rclxms.gif
*
haha the clogs has just been cleared ? thumbup.gif
TSerictioh
post Oct 2 2012, 01:09 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(chemistry @ Oct 2 2012, 12:36 PM)
Now I feel like installing a pair of Hella spot light. You got any advice for me? Any precaution during installation?
user posted image
*
The negative of the connection install to body ( best to touch together with the ground cable point).

The positive connection, make a relay from battery positive terminal. Others follow the instruction guide. thumbup.gif
TSerictioh
post Oct 2 2012, 03:15 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(chemistry @ Oct 2 2012, 01:48 PM)
sounds complicated to me.
I'll inform the installer about this.  smile.gif
*
Well, any question please contact me.
TSerictioh
post Oct 3 2012, 03:30 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(chemistry @ Oct 3 2012, 08:42 AM)
Usually ppl turn on spotlight together with high beam ?
I would like to put a toggle switch in dashboard so that I can turn on whenever I like. Is it feasible/possible ?
*
Yes this could be done by using a switch in cabin to control the relay which in then power up the lights.
TSerictioh
post Nov 1 2012, 03:52 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


all pmed..
TSerictioh
post Nov 2 2012, 12:14 AM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


All pmed... biggrin.gif
TSerictioh
post Nov 3 2012, 05:52 PM

Getting Started
**
Junior Member
62 posts

Joined: Sep 2004


QUOTE(gilaracing @ Nov 2 2012, 07:13 PM)
Bro, PM me cost for Waja.....not sure of the length, hopefully you do. Just need the following connections:

1. Battery to Body (as per the original route)
2. Bulkhead to Engine (as per the original route)
3. Battery to Alternator

Question: Wouldn't the car body itself act like a big block of earth on it's own? noob here.

Thank you.
*
pmed.

15 Pages « < 11 12 13 14 15 >Top
 

Change to:
| Lo-Fi Version
0.0213sec    0.47    7 queries    GZIP Disabled
Time is now: 15th December 2025 - 11:06 AM