Yes, new thread
More OC to come

Base on an otai's experience and some forums I searched, tFAW at 30 helps on prime 95 stability on Intel chips
So I suggest you try that for your friend's AMD chip as well

Yeah u should

Always count the 100% 1....whats ur temp at full load?

Let it run for some time~~
Then try to increase again your clockspeed

The latest version of the Scythe ninja

CPUZ basically states out your processor details, processor voltage, which revision, motherboard chipset info, your RAM info as well as your GPU info

Normally we use CPUZ or other softwares to check the voltages and etc etc under load (thats what I do)



This post has been edited by shinjite: Jul 6 2010, 07:15 PM

So far so good....let it run and see how

higher multiplier of 15.5 nice....

so ah_khoo, hows ur test with prime95 regarding the tFAW set to 30?

Yes increase voltage

Phase 1 completed



Phase 2 will be GPU + GPU block

Means tFAW 30 is not good for AMD

OC is about FSB cranking man, not multiplier

Crucial Ballistix Tracers are good.....I suspect its the LED that causes its short lifespan ~_~

Its darn hot.....

With new manufacturing process nowadays, both Intel and AMD can clock at high speeds~~
Those were the days where AMD 3Ghz was like godlike to achieve haha
For Intel, it was 4Ghz

Now....both can easily do 4Ghz (performance aside, switched places) haha

I think my WC setup not that optimised....stock speed 2.2Ghz at 1.1V, idle at 28c load at 38-39c. Any comments?

Even at stock speed and 1.1V?

I see, thats a lot of difference
Currently me priming small ffts (heats up the CPU a lot more than blend)
And also testing my Crucial Ballistix Tracer RAM, which just came back from RMA recently, running at DDR1066 at 2.1v (Its hot weh!!! although LED blink blink ler)
My OCZ Reapers keep aside first

Below is the screenshot

Full loading at 40-41c (non aircond, freaking hot today ~_~)

With tuniq tower CPU cooler, my idle also less tha 40c, around the 32-34c avg, full load around 50c

Now I am running on liquid cooling