CPU Level Up......................[Auto]
OC Tuner Utility
AI Overclock Tuner ..................[Manual]
CPU Ratio............................[13.5]
CPB Control..........................[Disabled]
CPU Bus Frequency....................[300]
PCIE Frequency.......................[100]
DRAM Frequency.......................[1600MHz]
CPU/NB Frequency.....................[3000]
HT Link Speed........................[3000]
> DRAM Timing Configuration
> DRAM Driving Configuration
************* Please key in numbers directly! *************
Extreme OV...........................[Disabled]
CPU & NB Voltage Mode................[Manual]
 CPU Voltage........................1.429 [1.400000]
 CPU/NB Voltage.....................1.442 [1.412500]
CPU VDDA Voltage.....................2.560 [Auto]
DRAM Voltage.........................1.700 [1.65000]
HT Voltage...........................1.310 [1.27500]
NB Voltage...........................1.310 [1.27500]
NB 1.8V Voltage......................1.802 [Auto]
SB Voltage...........................1.111 [Auto]
VDDR Voltage.........................1.205 [Auto]
VDDPCIE..............................1.113 [Auto]
DRAM CTRL REF Voltage................0.500 [Auto]
DRAM DATA REF Voltage................0.500 [Auto]
**********************************************************
CPU Load-Line Calibration............[Auto]
CPU/NB Load-Line Calibration.........[Auto]
CPU Spread Spectrum..................[Disabled]
PCIE Spread Spectrum.................[Disabled]


DRAM Timing Configuration

DRAM CAS# Latency....................7 [7 CLK]
DRAM RAS# to CAS# Delay..............7 [7 CLK]
DRAM RAS# PRE Time...................7 [7 CLK]
DRAM RAS# ACT Time..................21 [21 CLK]
DRAM READ to PRE Time................4 [Auto]
DRAM Row Cycle Time.................28 [28 CLK]
DRAM WRITE Recovery Time.............8 [Auto]
DRAM RAS# to RAS# Delay..............4 [Auto]

DRAM READ To WRITE Delay.............7 [Auto]
DRAM WRITE To READ Delay(DD).........2 [Auto]
DRAM WRITE To READ Delay(SD).........4 [Auto]
DRAM WRITE To WRITE Timing...........4 [Auto]
DRAM READ To READ Timing.............4 [Auto]
DRAM REF Cycle Time................110 [Auto]
DRAM Refresh Rate..................7.8 [Auto]
DRAM Command Rate...................1T [Auto]


DRAM Driving Configuration

DCTO Information:
CKE drive strength................1.5X [Auto]
CS/ODT drive strength.............1.5X [Auto]
ADDR/CMD drive strength...........1.5X [Auto]
MEMCLK drive strength.............1.5X [Auto]
Data drive strength.................1X [Auto]
DQS drive strength..................1X [Auto]
Processor ODT...................60ohms [Auto]
DCTO Information:
CKE drive strength................1.5X [Auto]
CS/ODT drive strength.............1.5X [Auto]
ADDR/CMD drive strength...........1.5X [Auto]
MEMCLK drive strength.............1.5X [Auto]
Data drive strength.................1X [Auto]
DQS drive strength..................1X [Auto]
Processor ODT...................60ohms [Auto]


CPU Configuration

AGESA Version 3.7.0.1

----------------------------------------------------------

AMD Phenom(tm) II X6 1035T Processor
Revision: E0
Cache L1: 768KB
Cache L2: 3072KB
Cache L3: 6MB
Speed   : 4063MHz
uCode Patch Level:       0x10000BF

----------------------------------------------------------

Microcode Updation..................[Enabled]
Secure Virtual Machine Mode.........[Enabled]
Cool'n'Quite........................[Disabled]
C1E Support.........................[Disabled]
ASUS Core Unlocker..................[Disabled]
CPU Core Activation.................[Manual]
 2nd Core..........................[On]
 3nd Core..........................[On]
 4nd Core..........................[On]
 5nd Core..........................[On]
 6nd Core..........................[On]



DRAM Controller Configuration

----------------------------------------------------------

Channel Interleaving................[Auto]
MemClk Tristate C3/ATLVID...........[Disabled]
Memory Hole Remapping...............[Enabled]
DCT Unganged Mode...................[Always]
Power Down Enable...................[Disabled]