hey, the worker in prime95 got state that the error occur whether in the ram or cpu core?

hmm, then got any hints to know that where is the error from?

yea, people usually connect extra fan to 4 pin molex direct from psu.
maybe avoid to put more load on motherboard.

This post has been edited by saturn85: Aug 4 2010, 04:44 PM

woo, you got 180mm fan?
what casing you are using?

woo, i don't want my quad core last so fast.

i m using the same processor as him leh.

yalo, even worse.
run occt, after 1 hour will got error on ramdom core (core#0, core#1, core#2, core#3).
and something funny is sometime windows calculator can calculate wrong value.

but i didn't try prime at dual core leh. when back to dual core, the cpuz will shows weird logo right?

then can i just enable 3 cores only? how to do that in bios?

woo, their clock speed is the same, but core0 will run slower.

hey, can set it to 3 cores? if yes, how to done it in bios?

FX gives 36 pcie lanes, while GX give 20 pcie lanes?
correct if i m wrong.

even with latest bios also start from 1.6v?

ram setting too?

ocz platinum DDR3 1333 7-7-7-20 1.65v?
are you sure want to put cpu voltage to 1.58v?

the DDR2 667 may limit the overclock ability,
unless you put the ram clock below 333mhz.

coil choke is this one?

or this one?


This post has been edited by saturn85: Aug 6 2010, 08:14 PM

modern board will have this ferrite choke.


This post has been edited by saturn85: Aug 6 2010, 08:11 PM

anyone know where to open this graph?
it is in which version of windows?


This post has been edited by saturn85: Aug 6 2010, 09:17 PM

but inside my windows xp task manager didn't have any system information.

yea, found it. it is actually Process Explorer.
http://technet.microsoft.com/en-au/sysinte...s/bb896653.aspx

woo, 4.2ghz stable on 1.387v.