Guys i am using Half 922 with GTX650 psu, i have my 4 pins mobo pin at the top most of my mobo, on top of my mobo i got my V6GT i m trying to reach the cable from behind, u guys think can reach it? cos from front seems a bit max out already, + that area is quite hard to reach as the V6GT is blocking it

alrite i ll try that out just afraid the cable will not reach it

thanks for it dude.. sorry for being noob first time work with cable

guys wanna ask if i remove my v6gt thermal cooler do i need to reapply the thermal paste again? i found that my vendor install wrongly now my V6GT light horizontally instead of vertically.

This post has been edited by kevinlim001: Dec 17 2010, 03:12 PM

how shd we clean the left over? the old paste normally use wat to clean?

hi TS in case u r still active

please add me in i am a user of
Haf 922
V6GT




This post has been edited by kevinlim001: Dec 20 2010, 09:55 AM

nah inside all very stock hehehe.. nothing much to share actually but another CM product is 650W GX

ya still working on the cable management. the vendor who installed for me left the whole bunch of cables in the casing i organize most of them to the rear of my mobo already.. only left some tiny casing cable flying around no time for that yet..

i doubt the chap who install my hardware actually knows the air flow is important..

another thing is my Haf922 actually doesnt have much place to hide my cable.. kinda sad..

This post has been edited by kevinlim001: Dec 23 2010, 08:11 AM

my fan only run about 500rpm optimum and about 800 on performance.. but which fan r u talking abt? processor or? my processor fan also running at about 1500rpm but it will reach 2200rpm on load

---

Added on December 24, 2010, 8:18 am
i m not sure about ur setup but this is the setup from CM official. if u put it as intake the only hot air exhaust will be at the rear.. you will suck alot of air but the air all trap within the case as the exhaust is too slow.. anyway do correct me as i am a newbie here

This post has been edited by kevinlim001: Dec 24 2010, 08:18 AM

y not try to lower down the speed when you do not want to use it? i tot V8 comes with a regulator..

my V6GT even worse it doesnt come with the regulator and it always run on max speed 2.2k rpm until i control it using Asus Fan Expert

I m not sure abt yours but there a the bundled software from my mobo allow me to sync the processor load the the fan load so my fan will always go with my processor

10% processor load = 10% fan load

---

Added on January 6, 2011, 6:20 pmV6 look like V6 engine ma V8 look like v8 engine ma nothing more expect the look and it doesnt equivalent to performance hehe

This post has been edited by kevinlim001: Jan 6 2011, 06:20 PM

guys any 1 of u using logitech nano mouse receiver on ur cooler master casing? i found there r some problem for the receiver to get the frequency = lag in mouse movement if i plug my receiver at the rear of my case