Hi, i tried to oc my proc few days back and i have this issue, after setting the OC and restarting the pc takes a long time to load the POST screen and right after that it skips the OC setting but if i remove either one of my DVD drive or HDD the OC works perfectly fine, i have tried switching the DVD drive and the HDD both time with the same results. It seems that the OC settings will only work with only one sata drive connected. Someone pls help

My Spec;

Intel Dual Core E6500 2.93Ghz
Gigabyte G41M-ES2L
Corsair 2Gb DDR2-800
HIS HD5770 1Gb
500Gb WD Green
Samsung DVD-RW
650W PSU

Steps That i have tried;
-Switching the Hdd and dvd-rw to a different one
-Increasing the Vcore voltage


The settings still revert to default setting after saving and restarting the pc.


Thx in advance

sounds like wrong SATA/RAM timing... how much your RAM clock...?

The ram clock is at the default, 400Mhz
Timings also default, 5-5-5-18

u manually set or leave it to auto...? sometimes auto mode will automatically increase them... :/

and how u OC and remain 400MHz...? how much multiplier and core clock u set...?

Erm, i think its better if i just show what happens before and after i try to OC.



Normal Setting




OCed Setting




After Saving And Restarting



My Max Multiplier is 11 btw

---

Added on June 14, 2010, 6:59 pmOk, problem solved, thx for the help anyways.

Solution;
Somehow my bios crashed when i was playing around with it and it was restored to an earlier bios version, i tried updating the bios and now everything works fine =)

This post has been edited by ryder: Jun 14 2010, 06:59 PM

change the SPD to 2.66

is the post screen stuck at some where? i try this before, my pc post screen stuck when detecting the dvd drive, the dvd drive after that is found to be spoil, after remove the dvd drive, it become normal again.