I dont think anyone in here is using that mobo...
Its a great budget mobo, maybe less feature than the SLI version but as far as performance is concerned, that particular mobo is not inferior at all to ultra-D...
but over 300HTT i dun know if the board can take it or not..
Are u planning on another bulk

More pics here:
http://forums.vr-zone.com.sg/showthread.ph...3178#post673178

Detail here:
http://www.madshrimps.be/?action=getarticl...274&articID=318

the vdimm option is limited to 3.2V

but is there by any chance that the limit can be raised? what i mean by is, what vrail does the dimms run on? any idea?

but 3.2v is more than enough for TCCDs

these board can hit 300++ FSB easily bro..

check out review at XS forum..

of course they used TCCD ram la..

bulk.. dont think so la.. but i already asked winc87..

This post has been edited by dinster: May 19 2005, 12:40 AM

RM420 ...
ask robyncom..this board selling at RM 380

what the DFI Nforce4 SLI premium board...coz i surf got SLI,SLI-D,SLI-DR...ahhhhhh...pening²

MSI Nf4 chipset or Via chipset better?



Amd 64bit cpu got unlocked and locked version like barton?

AMD64 non FX = multiplier unlocked down only
AMD FX = unlock multiplier up n down....

Robyncom always got em cheap

ic..it's same with locked and unlocked barton version too than..better go for FX version

how bout chipset? VIA k8t800 pro or NF3 ultra better?

better in terms?
OC = nforce better
functionality = nforce better (even get hardware firewall)
solutions = nforce better (single controller chip to handle bus n hw interface)
affordable price = via
performance/price = definately nforce

conclusion? u decide

antonio...finish burning already ka? what setting r u using...need a little help here...

For the tref , the best for the ram is 1168.

appreciate if u could share ur mem setting winc...

nop...not yet finish...still have to configure the fan blowing direct on to the fan...cilaka panas my ram....

winc87...give lar us dummies in Rams about ur setting....eheheheheh

sure no problem.

This is the settings for 250fsb at 3.4vdimm

Enabled
2
2
6
2
7
12
2
2
2 * 2 for 250fsb at 3.4vdimm *4 for 260fsb at 3.6vdimm
1168
Auto / 1
Enabled
Increase
0
level 6
auto
auto
Fast
auto
256cycles
Disable
16x
7x
Disable

Btw , i'm using 510-2 bios.

My settings might not suit your ram. PLease do not be lazy to spend hours to tweak your ram. Trial and error is the key.

This post has been edited by winc87: May 20 2005, 11:05 AM

aiyakkk..DFI mobo bios...how am i gonna understand...muhauhauhuahaua....

u can go figure using A64 tweaker

wahhh lann...how figure wan...line 1 until 7 mebbe can lar...after that all hantam wan...hahahaha..sure cannot wan

thanks winc...
antonio...how's ur burn-in...mine not so good la...always tons of errors...and when i said tons, i do mean tons...that's why i asked winc for his setting...maybe can start from there...now burn-in testing one at a time...