my old BT-D43 maxed at 255mhz@3-4-4-8 2.85Vdimm wif a P4 2.4C running dual channel..but wif a 3.0E,can only do the same speed/timing/vdimm on single channel..dual channel is only stable at 245mhz..sheesh

This post has been edited by x800: Jun 27 2005, 07:34 PM

priming two sticks of BT-D43s at ddr520 2.5-4-3-5 1T @ 2.85V will try to see how long it will last.

This post has been edited by x800: Jul 21 2005, 05:06 PM

hurm,i think i am a bit lucky with these rams.my old 512x2 bt-d43 only do 250 3-4-4-8 2T..

*update* i restarted prime.my rams did the same speed n timing after 7 hours 30 minutes



This post has been edited by x800: Jul 21 2005, 05:11 PM

updates on my 2x256 BT-D43s, i ran memtest at 258fsb,dual channel,2.5-4-3-5 1T,2.85v, and it was stable even after i left it bout 6+ hours overnight tried 259fsb, but errors started to show up after about 1 n a half hours

hurm..i have a question ere bout heat from these KVRs.i just added 2 more modules, so now im running 4xBT-D43s modules (256MB each) at 2.85V..the question is,do i need heatspreaders?i've touched the rams after i shut my pc down, and it feels kinda warm..currently i only have a 12cm fan at my side panel blowing to the modules n cpu..

hurm,i think its better if u try and find the best settings urself.coz that's what i did.i tweaked by following a guide in the extremeoverclocking forums here and it definitely gave me better SuperPI results.

i'm not using a DFI nf4 mobo, but anyway here's my 24/7 ram settings



note that i had to use 2T coz i'm using 4 modules of 256MB.if only 2 modules,then only can use 1T

crazy, but not impossible lor.already got one forumer reaching DDR600 wif relabelled KVRs, but very loose timing of course...IIRC his name is Wadieq

hurm, IMO it's ur cpu that's limiting the fsb n the ram.but if u've already tried with other rams that can reach higher fsb wif the same 1:1 divider, then most probably its the ram.3.68ghz is already high and good for a northie on air cooling bro..

This post has been edited by x800: Sep 13 2006, 10:41 AM