doesn't be any issue that the ram doesn't fit it.
except u r using ddrII, or might be sd-ram.

what do u mean by feedback?
oc potential? compatible issue?
warranty? price?

rev5.2 can't help...

but some people manage to get this type of promos go above 27x~280...
mayb u try out by searching promos chip performance.

Nice one there.Did you try clock it in bios?can boot?

let say give it a chances to run 32mb calculation? if pass, then preety sure ita stable ady 

I don't think it will pass.Clockgen clocked 325 HTT (cpu-z 1.392v ) while bios clocked 322HTT (cpu-z 1.44v).Clocking with clockgen is easier comparing clocking in bios.

You mean Cpu-z didn't show the exact value?It is normal,software reading always incorrect.

walao wehh.. ur venice can do the same wif my opty ady   
btw, wat ur RAMs speed??

You have a killer E6 venice.
What's the stepping?

hahaa.. our setup kinda same speed except my L2 cache lil' larger than ur.. lolX
btw, ur vcore higher than mine coz i let it in AUTO mode for CPU Vcore..   

yupp.. ur faster than mine. my pi 1mb was 31sec while 32mb were 27min   
anyway, my vcore was 1.36v(SmartGuardian reading) & BIOS was AUTOs 

hy there, my SLI-DR capable doing at 440HTT @5x Multiplier, after going beyond 445, hang already, 440HTT is bootable - just wan to noe how far my SLI-DR can go, btw i'm using A64 3000+ now running at 2.9GHz failed priming after 2hrs    at 1.4VCore oni

DFI Lan Party is very unstable! Better buy ECS. Can OC my 3000+ winchester to 2.9GHz stable, prime 48 hrs.

Hello,

Can anyone help me?
I sold my previous 66GT PCI-E because i'm going to upgrade to a better card soon.
Okay,here's the problem.I bought a used PCI 8mb graphic card and plug into my SLI-D's pci slot.The monitor's led turn into green which mean there's signal going to the monitor from the VGA card,however the system just freezed(blank screen) without any progress but the monitor led still in green light.

Any idea?

The problem is with my DFI LP SLI-D board so this Q shouldn't be here?
I'm not a new DFI user,everything done and it's still the same.

This card using S3 Trio64 V chip.Don't know what is the brand.
Tried with my both SLI-D and eXpert,no go but with old Pentium3 can boot.

Anybody have using DFI Lanparty with psu Enermax FMA series? I'm using 535 watt can boot but after using with 460 watt, the fan on psu still run but no display.

hi guys, i'm a new LANPARTY UT nF4 ULTRA-D user here.
sorry if this questions have been asked b4.
i tried to make my ram to Dual chanel, so i plugged my ram at slot 2&4.
but every time i did that my mobo can't turn on and i t gives beep sound..

but if i plugged it in slot 1&3, it's still single.. please some1 help me pls? thnx~!!!

does this means i have to put bth of them in orange slots? thnx~!!!
neway, i'm just wondering why i can't push my opty 144 further?
damn.. hehhe laugh.gif the max i can get is 255mhz (2.29Ghz)
i did try raised the vcore for 260mhz... but always get BSOD...
can somebody help me? thnx~!