Outline ·
[ Standard ] ·
Linear+
DFI nF3/4 series (LP and Infinity) users come in, Overclocking ability and troubleshooting
|
pcmoddingmy
|
 May 20 2005, 02:35 PM
|
|
QUOTE(chris251285 @ May 20 2005, 02:14 PM) i've a very big prob .. i can't turn on my board !!! spec is ULTRA-X 500 W True power, gigaram 512*2 , AMD 3200+ wonder y can't i turn it on ... any clues ? anything tht i need to do 1st ? tried resettting cmos .... pls help ! .. tried changing ram ... Did you connect the 4-pin molex and floppy molex to the motherboard? |
|
|
|
|
|
pcmoddingmy
|
May 20 2005, 02:42 PM
|
|
|
QUOTE(kianwee @ May 20 2005, 02:38 PM) It's your PSU, fancy but  The PSU is good enough... tested on DFI LAN Party NF4 before. So I doubt it's the PSU. |
|
|
|
|
|
pcmoddingmy
|
May 20 2005, 07:39 PM
|
|
|
QUOTE(chris251285 @ May 20 2005, 07:38 PM) thx man .. but where to get tht bios ?  .. and sory for misunserstanding as my post is kinda messy .. solved my prob though changing the stupid gigaram to transcend You can get official DFI BIOS from www.dfi.com.tw |
|
|
|
|
|
pcmoddingmy
|
Nov 4 2005, 03:38 AM
|
|
|
QUOTE(almostthere @ Nov 1 2005, 06:02 PM) OK, this sounds stupid but am thinking of my options for my upgrade. Here's my question: Are there any modded BIOS's for the Lanparty UT nF3 Ultra D which allows VDIMM selection upto 3.3v or not? Please do tell me and if possible link to me the work around to it Hey mate, The problem with nF3 Ultra-D is the actual VDIMM will never go above 3.2V even if you selected 3.3V through the BIOS. The hardware is the limiting factor here..... not the software. Therefore, I suggest that you grab a DDR Booster and match it up with the motheboard. I've been messing with the nF3 Ultra-D before and managed to do 3.6V with the Booster. Anyways, this thread is purely for nF4... isn't it? |
|
|
|
|
|
pcmoddingmy
|
Jul 18 2006, 06:33 PM
|
|
|
Anyone here tested the Infinity AM2 motherboard yet? I just received mine today (Infinity NF Ultra II-M2) and can't wait to put it on the test bech. This thing has dual PCI-E slots and the layout is similar to Expert/Venus/RDX/CFX series. I checked the chipset and it uses nF4 Ultra chipset, which is same as nF4 Ultra-D. However, it looks like "points" on chipset was enameled to prevent users from "SLI-enabling" it. However, I recently learnt that it will still be possible to run SLI on any mobo with dual PCI-E slot, thanks to modded FW drivers!  Sadly, my Cybershot decided to die on me yesterday... so I can't take/post any pictures yet. Edit: Perhaps I should start a new thread for DFI LP/Infinity AM2 series? This post has been edited by pcmoddingmy: Jul 18 2006, 06:34 PM |
|
|
|
|
Quote
0.0389sec
0.51
7 queries
GZIP Disabled