to nf4 ultra-d users, i have a question..

the mobo has 4 power input which consist the 24pin, 1 4pin, 1 molex and 1 floppy.. should i plug all the power or can i just plug in the 24pin and the 4 pin coz i'm running out of molex space..

guys i have a prob..

i'm using nf4 ultra-d and it seems that my chipset is always running at 52 degrees.. checked it using smartguardian.. is it because my gc is just on top of the chipset fan?

i've done a bit of oc but the temp 4 my cpu and pwmic is 39 on idle.. just that the chipset is idle at hi.. pls help..thx

hi.. i have a prob with my mobo.. everytime after i o/c, my bios will reset 2 default once reboot.. i'm using the latest bios btw.. now i'm checking if my mobo's batt. is dead or not.

pls check my sig for my hardwares used..thx

guys i have a prob here.. It seems that whenever i turned off the wall plug switch to my pc and turn it on , the bios will give a warning and stated that it's in safe mode. it ask me 2 like reconfigure the cmos setting. My settings all were reverb 2 default setting. This doesn't happen if i just left the wall switch on when i shut down my pc.

Another thing is, now i can't o/c my opteron to 255 fsb which i always do. My pc will hang during start-up. I can't even reach 240 fsb without getting hang. I suspect that my mobo's batt. causes the prob.

any1 can help? pls..thx

^ i hope so.. it's better than getting my cpu or mobo spoilt..

btw, does weak battery really effect my o/c potential?

i know, what i mean is does it effect that i can't o/c my fsb as high as i usually do.. i know it'll get resetted but y can't i get higher fsb?