Aug 12 2010, 10:16 AM
QUOTE(formalin @ Aug 5 2010, 04:22 PM)
1.After the basis full auto MCACC setup how do we proceed to The Advanced MCACC?
2.Do we set the speakers size first then MCACC or after MCACC then set speaker size?
I did the auto MCACC, the speakers size always come out Large even I’m using KEF3005SE which are small 5.1 speakers.
After setting to small,when I run MCACC again it sets it back to large. 
3. What is the best sub crossover for a small room of 11’X14’, any how my input is 100HZ..any help in this area?
4. Another thing is, it sometime show my center speaker as Reverse Phase even the speaker are properly connected, it drive me nuts .…I just ignore it and proceed with the calibration... 
Just another fellow user of KEF3005SE but I am not commenting on MCACC as I am on an Audesi based AVR. Just some input on the KEF3005SE.2.Do we set the speakers size first then MCACC or after MCACC then set speaker size?
I did the auto MCACC, the speakers size always come out Large even I’m using KEF3005SE which are small 5.1 speakers.
After setting to small,when I run MCACC again it sets it back to large. 3. What is the best sub crossover for a small room of 11’X14’, any how my input is 100HZ..any help in this area?
4. Another thing is, it sometime show my center speaker as Reverse Phase even the speaker are properly connected, it drive me nuts
.…I just ignore it and proceed with the calibration... 1. I noted that with the Port Bung out, setting will be Large, try to keep the Port Bung in during calibration, see if it helps.
2. Recommendation for Sub-woofer crossover are between 80Hz to 120HZ. Try to see which one less boomy. Mine set at 100HZ also and I put my Sub-woofer on a Subdude
3. Mine not with the centre. Its either the front left or right. So I also do the same thing.. I ignore also. Not sure why yours the center channel.
Quote
...I did not touch it yet as still new from box..
0.0317sec
0.49
7 queries
GZIP Disabled