high 6xC - >65C <69C? low 9xC >90C <95C? ...

This morning quite cold, CPU down to 39 and 41 under full load

It works? the passive active...

Last time tried on my friends, don't see any difference...

Voltages is different from one CPU to another even it is the same models...
Need to test yourself

Should be fan on or off...

Run some benchmark, see the temp?

Open up S42, find the PLL and use setFSB to overclock?

BBX, considered PLL pinmod?

This post has been edited by lee_what2004: Mar 19 2010, 10:53 AM

Last time tried, can't boot

Just take out the copper wire? Then can boot again...

Got one person burned his CPU iinm....

Not the same, even if it fits, you would need to find a new heatsink for it since it got 2 die now

active better but noisy....

Use table fan + air-con room

want, your AV avatar is just...

This post has been edited by lee_what2004: Mar 19 2010, 07:41 PM

Thinking of this

Can play if you don't mind the lag

Well, the most important one is the lowest and max....

factory default is stable, but its not always the lowest voltage since its impossible for them to test one by one...

The lowest and highest multiplier...
Yours is fixed?

At the least, for my situation, I still can lower more the voltage for the lowest multiplier, since its quite high...

I don't have SuperLFM
It should show SuperLFM on the "Type"

This post has been edited by lee_what2004: Mar 20 2010, 01:48 AM