can someone provide me with a guide to attach LEDs onto non-LED performance fans?
i have a few Scythe Slipstream 110cfm that i would like to mod.. thanks
Adding LED to Non-LED Performance fan, please help.... T.T
|
|
 Jan 20 2010, 10:03 PM, updated 16y ago
Show posts by this member only | Post
#1
|
 
Junior Member
241 posts Joined: Jan 2010  
|
|
Quote|
|
|
|
|
Jan 20 2010, 10:12 PM
Show posts by this member only | Post
#2
|
Senior Member
1,186 posts Joined: Aug 2009 From: KL & PG 
|
QUOTE(shanetsh @ Jan 20 2010, 10:03 PM) can someone provide me with a guide to attach LEDs onto non-LED performance fans? errm why dont u just get a new fan with leds i have a few Scythe Slipstream 110cfm that i would like to mod.. thanks   anyway i have never seen any one doing this before  i think this guide might help http://forums.bit-tech.net/showthread.php?t=154804 |
|
|
Jan 20 2010, 11:28 PM
Show posts by this member only | Post
#3
|
Senior Member
2,765 posts Joined: Nov 2005 From: **Hornbills** 
|
u can ask allngap for guide
 |
|
|
Jan 20 2010, 11:59 PM
Show posts by this member only | Post
#4
|
Senior Member
1,800 posts Joined: Dec 2008 From: unknown
|
actually its possible.. i've seen some1 did with a yate before..
|
|
|
Jan 21 2010, 11:06 AM
Show posts by this member only | Post
#5
|
Senior Member
939 posts Joined: Jan 2007
|
QUOTE u can ask allngap for guide i think sifu retire liao  drill 5mm hole at the corner of fan,then put led. solde them then can liao.  This post has been edited by lun1986: Jan 21 2010, 11:08 AM |
|
|
Jan 22 2010, 07:13 PM
Show posts by this member only | Post
#6
|
|
Senior Member
2,765 posts Joined: Nov 2005 From: **Hornbills**
|
QUOTE(lun1986 @ Jan 21 2010, 11:06 AM) i think sifu retire liao retired still ok what..TS askin for some guide..not askin to mod it for him drill 5mm hole at the corner of fan,then put led. solde them then can liao. |
|
|
Jan 23 2010, 10:12 AM
Show posts by this member only | Post
#7
|
Senior Member
1,632 posts Joined: Oct 2007 From: Sea
|
bro allngap.. seldom on9 liao...
u can try yourselves by drill 5mm hole using small drill bit... then solder wire.. connect wire to fan motor.... |
| Change to: |  0.0161sec
 0.50
 5 queries
 GZIP Disabled
Time is now: 21st December 2025 - 11:43 PM |
All Rights Reserved © 2002- 2025 Vijandren Ramadass (~unite against racism~)
Powered by Invision Power Board © 2025 IPS, Inc.