Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 Nissan Sentra/Pulsar/Sunny/Lucino Owners Club V2

views
     
silverthana
post Aug 20 2011, 12:27 PM

New Member
*
Newbie
0 posts

Joined: Aug 2011
I have nissan sentra B14 GA16 engine 1995 Auto gear.The FC too high,sometime have black smoke.engine stop at traffic light.My mechanic said some sensor have problem.I bought consult from internet then used this consult to check.
Diagnostic trouble code shows CODE 11 CRANKSHAFT POSITION SENSOR ERROR.My mechanic and my self have
seach for this sensor location hours but cannot found the sensor location.He said normally at gear box near flywheel or at engine block.but we found nothing.Need help if anybody know where is this Sensor are really located.Thanks
silverthana
post Aug 22 2011, 04:59 PM

New Member
*
Newbie
0 posts

Joined: Aug 2011
QUOTE(lot101 @ Aug 20 2011, 12:59 PM)
its inside the distributor cap......there should be an oil seal failure in there. you have to replace the whole assembly, dun buy potong kereta one. Long run new is cheaper. Source for it in spare part shops.
*
have open the cap but there are plactic cover.how to remove the cover to check internal parts.just pull only ke.You mention to replace the whole assembly that means to replace the distributor one set ke.Sorry asking bodoh question.
thanks
silverthana
post Aug 23 2011, 12:50 PM

New Member
*
Newbie
0 posts

Joined: Aug 2011
hello all sifu,just want to know about Ignition Distributor for B14 GA16 1995.I have check at spare part shop in Ampang,the price for brand new complete.for Taiwan made price RM300.Original Nissan price RM600.
He advice not to use recond or potong kereta type.Any body have used Taiwan made before,any problem ke.or I need to buy original Nissan for my car.please help me.thanks
silverthana
post Aug 24 2011, 07:06 PM

New Member
*
Newbie
0 posts

Joined: Aug 2011
hello my nissan B14 GA16 Today replace Ignition Distributor bought from Potong Kedai cos ny mechanic said it better than brand new Taiwan made.After fixed /test etc engine running OK,I take the car and drive home.Alamat'after 1km.car start jerking and later engine stop.start also cannot.I call back the mechanic,he came and replace back my old Distributor.so I can drive car to my home.I think I will used Taiwan made Distributor maybe after raya,now all workshop are fully booking busy for balik kpg servicing.may be others B14 owners also have the same experience with potong parts

 

Change to:
| Lo-Fi Version
0.0189sec    0.36    7 queries    GZIP Disabled
Time is now: 20th December 2025 - 09:00 PM