B14 sentra ga16de manual transmission here.

This post has been edited by Samboi: Apr 10 2018, 08:09 AM

Damn. I need a hood for mine. 😥

Check the radiator/coolant overflow for rust, make sure it doesn't overheat, if manual check the clutch cable in case it's stretched and check to make sure it goes in all gears, if 1st gear difficult may need new shifter bushing.

Make sure intermittent wiper works (the relay/amplifier for it is like rm 200+) check the horn relay/horn. I had to relocate my button for now until I can get a new steering wheel hub and relay. Right now it's a push button and two wires bypassing the relay.

Check for rust. Check the belts(these were a pain to find) . check the oil and make sure it isn't milky(milky=blown head gasket)

Check all lights work, check air-con, check brakes, suspension and ball joints/bushings/ etc



Basically anything you would check on any other car.

There is a screw on the idle control by the throttle body you can adjust idle with. I adjusted it too low because I had high idle and it died everytime I push in the clutch and let off the gas😂😂
Adjust it a bit higher now everything okay

This post has been edited by Samboi: Apr 18 2018, 09:10 PM

Does anyone know the belt sizes for ga16de I've checked so many sites and all of them give different size for the alt/compressor belt.

Many say 6pk1120 others say 4pk1015 or 4pk1020 or 4pk1110

Mine is worn to the point where there is no writing on it....

This post has been edited by Samboi: Apr 26 2018, 02:24 AM

anyone know where to get a fuel filter? or should i just use one for a waja since they are the same type?

I ended up order a New old stock from Japan, cost like RM44, I think maybe can check around local fixit shop and get for like RM20 though. The filter is a pain in the ass to get off also.

You have to fix the paint on your roof yet?
I fixed 3 rust holes and now they are coming back again. I know I have to take out the headliner and fix properly but I dont have time yet haha
need to get a sander or grinder because sanding by hand takes forever.

One good place for spare parts is the B14 owners page on facebook people always posting parts on there and can post there if need parts, someone usually has some. https://www.facebook.com/groups/1779212342356330


There is one shop in Puchong close to D'island that basically only works on b13,b14,and b15 sentra. its next to the 99 speedmart I cant remember the name off hand but it has a high rev sign.

2, Jalan Putra Perdana 2/3, Taman Putra Perdana, 47100 Puchong, Selangor(this is the address for the speedmart)

This post has been edited by Samboi: Nov 28 2018, 01:59 PM

yeah, i didnt know I could use a wira filter they dont really have parts interchange books here.... :haha:

I noticed the b14 here actually has a lot of differences in parts compared to the US model and the Japan. Especially belts and the position of the pulleys. the belts are a lot shorter here and are 4pk instead of 6pk.

I just realized you said oil filter, RM44 is for the fuel filter... the oil filter i paid like RM12 when it was on sale