fan mod
|
|
 Jan 17 2010, 01:11 AM
Return to original view | Post
#1
|
 
Senior Member
717 posts Joined: Oct 2008 
|
QUOTE(kInOzAwA @ Jan 13 2010, 08:28 PM) i have a Delta fan that i purchased from someone which is using molex modded to 3 pin. When connect to a fan controller it works, but there's no display available to tell you exactly the rpm number running. can someone direct me to a thread that teaches you how to mod molex to 3-pin ?  someone told me if plug delta fans to motherboard will fry the motherboard, hence have to connect to PSU. can explain a bit ? |
|
|
Jan 17 2010, 02:02 AM
Return to original view | Post
#2
|
|
Senior Member
717 posts Joined: Oct 2008
|
QUOTE(topazzatale @ Jan 17 2010, 01:24 AM) thanks broQUOTE(mADmAN @ Jan 17 2010, 01:30 AM) not advisable to connect a fan with more than 0.8A to the motherboard....too much current draw will stress the mobo components and might end up kaputed... Hi Madmani once tried plugging in a delta FFB1212EHE 3.0A fan into a mobo while the PC is on.......plug in only straight the whole rig turned off... shut down, unplug the fan then the rig can power on again. so the only way to control these high cfm fans is through those special fan controller...  haiz have to spend $$$ again This post has been edited by kumanosuke: Jan 17 2010, 02:02 AM |
|
Topic ClosedOptions
|
| Change to: |  0.0151sec
 0.44
 6 queries
 GZIP Disabled
Time is now: 22nd December 2025 - 08:28 AM |
Quote
