Welcome Guest ( Log In | Register )

Outline · [ Standard ] · Linear+

 The Official Subwoofer Thread v3, Everything you need to know about bass!

views
     
Hwoarang45
post Dec 13 2011, 02:06 PM

Hardcore Gamer
******
Senior Member
1,848 posts

Joined: Jan 2003
From: Boleh Land


yay finally brought my new sub after soooooooooo long... suffering from roger boomy sub...
Velodyne EQ-Max 10 user reporting here... sound awesome for my tiny room~~! any other owners of this sub can share your settings?

wanna ask i set my sub to 180 phase, and i place my sub to i palce middle of room sideway , is it correct?



====================================

QUOTE(jchong @ Nov 27 2011, 09:45 PM)
The additional output from Y-splitter is just the same effect as turning up the volume knob. So there is no need to waste money getting the splitter. Remember the splitter is not magically increasing the capability of your sub.
*
hmm i been wondering about tat too, thanks for clearing it up

QUOTE(SunofaBeach @ Nov 27 2011, 09:50 PM)
Oh? Thanks for the advice pal! Save me some quids  laugh.gif

Anyway, I have had my setup all in ''Large Speakers'' decided by the auto calibration and recently realised good bass management suggests that all speakers set to ''Small'' let all the LFE pass to the sub.

I had a go and discover bass is increased tremendously however in some certain part, bass sounded bit too much and bloomy, I am not sure if I should switch back to ''Large Speakers'' Setting or stick with small but tweek a bit on the subwoofer setting
*
what receiver or amp u using, i just finally tune my set up nicely , since i upgrade my receiver to Yamaha RXV771 and Velodyne EQ-Max 10, what i does is i set my sub to 50% volume ,eq off, and let yamaha YPAO sound optimisation to tune my set up, end up, the cut off to sub is about 120hz volume -2db, but i increase it to +2db , sub volume at 45%... so far its tight and no boomy sound for my small room, i have a 4m x 3m room . hope this helps...
Hwoarang45
post Dec 19 2011, 05:41 PM

Hardcore Gamer
******
Senior Member
1,848 posts

Joined: Jan 2003
From: Boleh Land


haha i taught im the only one has small room for my av set up, suck right ?
i have problem now, when my sub goes low , a part of my ceiling vibrates.. haiz... dunno which pieces.. need to nail it in..... sad.gif anyone has this problem? im living in a single story, using those old 4x6 ceiling board.. made of cement i think..
Hwoarang45
post Dec 24 2011, 12:38 PM

Hardcore Gamer
******
Senior Member
1,848 posts

Joined: Jan 2003
From: Boleh Land


yeah save alot on cables, hmmm maybe u can try different cut off frequency, from 120hz to 80hz and see..
Hwoarang45
post Dec 27 2011, 10:46 AM

Hardcore Gamer
******
Senior Member
1,848 posts

Joined: Jan 2003
From: Boleh Land


QUOTE(SunofaBeach @ Dec 26 2011, 07:26 AM)
I think my amp doesnt do Audyssey  sad.gif
*
what receiver u using? i think properly set the ideal cut off for your front and sub will balance out the ideal listening bass u seeking...try it ..most simple options now..

QUOTE(ckf8829 @ Dec 27 2011, 01:02 AM)
Hi,

Want to ask where can i buy a remote control for velodyne spl ultra series. Mine 1 was missing. Is there any other device can replace? Thanks alot
*
buy a cheap logitech universal remote, then map from a velodyne or see if they got supported in their list itself, cheaper and more practical than order on-line, u can control multiple stuff too

 

Change to:
| Lo-Fi Version
0.0491sec    0.61    7 queries    GZIP Disabled
Time is now: 9th December 2025 - 10:08 PM