Outline ·
[ Standard ] ·
Linear+
Project Lian Li PC-A71F, pc name: Mognet
|
moderno
|
  Dec 17 2009, 05:56 PM
|
|
QUOTE(Moogle Stiltzkin @ Dec 17 2009, 09:14 AM) Nope. Pc perspective have the stock :/ I would 110% buy from sidewinder again, sadly they don't have some of the stuff i need :/ Well they have the fans but it would be more expensive paying shipping from 2 different shops >-<;
Added on December 17, 2009, 3:04 pmOk the panel was cut. See clean cut     how much for the cut bro?  |
|
|
|
|
|
moderno
|
Jan 5 2010, 04:46 PM
|
|
|
QUOTE(kevink82 @ Jan 5 2010, 04:21 PM) i think the sticker on the other side ruin the class of the case ; ; btw any reason y the pump is like........ sideways? rest of it looks good . the pump has to be mounted that way coz of the inadequate spacing at the casing base to mount it straight..else if wanna close the sidepanel...the pump will be pushed inward and bend the inlet tube from reservoir  |
|
|
|
|
|
moderno
|
Jan 5 2010, 06:12 PM
|
|
|
QUOTE(kevink82 @ Jan 5 2010, 05:39 PM) he should be ok its pretty easy to move the res although im not sure bout water pressure drop though isnt it a bad idea to add 2 90 degree right before the pump? the MCP655 can push the flow easily no problemo..and furthermore the res is on top thus providing gravity flow towards the inlet of the pump...the use of 2 x 90 degree compression fittings will not decrease much of the MCP655 performance rate.... This post has been edited by moderno: Jan 5 2010, 06:17 PM |
|
|
|
|
|
moderno
|
Jan 5 2010, 08:30 PM
|
|
|
QUOTE(kInOzAwA @ Jan 5 2010, 07:56 PM) nice setup and neat cable management as always from moderno. anyway for the pump, i think there's another solution from the current setup where the pump located just below the res. it's the best setup and seems the position of the pump location is better in that way, while the 2nd 90 degree rotary for optional exit of water from res can be put in a more convenient place  we've tried position the pump just below the res in pre-design loop...but there's a problem to route the outlet tube from the pump to CPU as it'll interfere with the res itself... QUOTE(kevink82 @ Jan 5 2010, 08:19 PM) he has a drain port at the bottom of the res if u look carefully not sure how u access it quiet tight by the looks but good craftmanship on modernopc i cant even c a scratch on the side panels  got special way to drain out water from the res via that drain port..  |
|
|
|
|
Quote
0.0217sec
0.48
6 queries
GZIP Disabled