Isit me or the alienware casing's interior sucks? D;

Single sleeve cables always look nice. I see there are too much cables routed just beneath the graphic card. Won’t it block the airflow? Good looking case there. 

LOL Just change the casing

That casing looks like only support up to mATX... What is that extra electronic board below the 5.25" bay?

After Cable Management..~

Trying to route the cable's again later today and see how it works. If not, time to drill the back of the case.

---

Added on September 10, 2011, 4:14 amWell, to me the interior seems to more suited for pure water cooling instead as there are quite a number of mounts for it but for now it works for me. Built quality is actually not bad but it could be better.

For example, interior chasis could be powder coated instead of leaving it bare or have a proper cable management slots. The plastics are actually quite good quality except that the paint coat is quite thin. I am planning to powder coat the interior again to a different color and repaint the exterior chasis with glossy paint instead.

It has always been an awesome brand/maker until "Dell" took over. Some cost cutting saving methods is quite visible for some areas.


This post has been edited by satinblack: Sep 10 2011, 04:14 AM

my camera got problem,i use webcam.   
better than before.. but still messy.. i think need to drill the case like satin said.. but,dun have the eqpmnt.