To disassemble BD Mk.3.... For modding

1. pop the 2 hard screw cover out, unscrew.

2. pop the arms out of the ball sockets.

3. peel the reddish rubber (Pic:Right, middle) from the shoulder hole. They are attached by glue to the front and back piece at the edge. (Actually you just need to peel it from either, front/back torso piece, as the shoulder sockets it attached to the back, it maybe better to just peel the front).

4. Grip the front and back piece and carefully pull them apart.

5. They might have glue the abdomen rubber piece to the front piece as well (at least my copy.
.....just the screws and the rubber pieces covering the shoulder hole keeping the pieces together.

p.s. Mk,3 ver. 1 has 4 screws.... 2 are hidden by under the shoulder flaps at top (glue attached, that you'll have to pry out).


I'll be doing 2 mods (at least)
1. Widen the side articulation of the Torso/Abs (a surprise and discovery: The waist/abs has very similar articulation to a TT body. 2 articulation points, Top (Torso/Ab) is a ball joint, Bottom (Ab/Pelvic) is the (I think) spring loaded (identical to normal TT Ab/Pelvic joint). Abs articulation limited by bad design and rubber outer covering.

2. Raise the shoulder guards/armour a little to allow the arm to be close to the body (more range) without the shoulder armour getting in the way.