Sheva Alomar arms (and torso) review (Hot Angel body with seamless arms)

Torso (internal and rubber body) very much the same as other Hot Angel body (Machiko/Female ERT/Silken Floss)

Upper torso held by 5 skrews
Lower torso by 4.
Ball joint for the lower ab to pelvic joint.
Spring loaded all-direction mid torso joint

About the arms

-The internal of the arms (metal/plastic) are cast in silicon moulds (from shoulder to at least 3/4 down the forearms).Because of the casting in a mould, each arm in relation to its external silicon skin will be unique.Bad casting may result in thin silicon areas that may prone to tear.

-Popping the ball shoulder joint out of the torso is very hard (at least my copy compared to previous Hot Angel/Chacha). I had to loosen some of the 5 screws of the upper torso.

-Some type of glue is added to the area at shoulder joint (green arrow, pic 3).

-Spring mechanism in each arm as indicated by the red arrow (pic 3) gives the ratcheting feel (resistance) to the bending of the elbows.

-Elbow hinge can be bent to about 140 degrees (pic 2), ...not 100 degrees.... but you'll be stressing the silicon.

-Shoulder joint far exceeds the 80 degrees limitation as stated on the instruction manual, overall around 180 degrees (green arrow, 3rd pic). Again you'll stress the silicon covering the shoulder.

-Very hard/un-giving Alloy composite metal is used for the internal of the arms. Wrist joints are difficult to be removed from the metal loop (at least my copy, black arrow, pic 3)

-The plastic part of the internal arms are not similar in shape or thickness. The thick part of the left arm as indicated by the blue arrow (pic 4) may give rise to very thin silicon outer layer at the area below Sheva's tattoo (my copy).

-Sheva's left arm is painted and the paint may peel off as shown in forearm area in pic 5. I suppose a type of silicon based paint is used and the tattoo is painted or attached to the to layer of the paint, Her right arm is not painted.

pic 1


pic 2


pic3


pic 4


pic 5