this is what i was askin.. however i think the price is still quite steep

i juz wanna share wht happened last month. a friend of mine installed HID on his neo and summoned by JPJ at KLIA roadblock. during his chit chat with the officer, officer said only cars with factory spec HID are allowed. the jpj also added even old waja cannot install HID. only waja CPS allowed to have HID 

to answer those questions on new waja CPS HID.. is actually it can be done.. coz the J*J is refering to old waja can't install HID in the lamp and only CPS waja can.. my bro also said that as long as its campro u can use install HID.. this is bcoz HID started with Waja MME aka waja R3 and its a campro.. based on that the campro is legal using HID.. as for old waja.. u can buy the proton product of HID as it is original proton headlamp HID same as the R3 product(just that R3 is blacken).. using that is not a problem since ur not installing tha HID in the lamp but using an original HID headlamp..

I think if use the original Waja HID is ok..coz legally manufactured..
Then if stop by police/JPJ can claim it's original..no more normal headlight..

Pics below showing WAJA CPS headlight with ballast pre-installed

few week after i receive my car..on my journey home to kl, i face a roadblock @ old kuantan pahang road@1am in the morning..tis jpj officer stop me and ask me me to pull over..and he asking me about my headlight..then he check my rear bonet..after tht he apologise and ask me to leave..i ask y..he said my car cps model..he tot normal waja use HID...R3 HID is dark titanium..not soo obvious compared to cristal or white 1...IMHO R3 more fancy..
agreed coz.. proton HID onli 4500k...aftermarket usually minimum 6000k ++...but cheap compared to Proton HID...ori 1 cost u 1.2k++ for 1side onli ..got to be more carefull wif my headlight

there is a huge diff for ron95 and ron97

shouldnt be a problem as all cps models are using it
haha, installation also can bulk, wth man..
not yet, suppose to install it later, but the seller got urgent things to do, so anybody who would love to install the gated gear can tell me, i asked him already, he said got bulk price 

to stabilize voltage around the car. sometimes the voltage in your car might have a sudden surge and cause bulbs to blow. just found out that waja only has ONE grounding point. so adding a few more would have very obvious results

so far for my car the most noticible effect is lighter and better throttle response. tonight will test and see if lights still dim when switching on indicators etc. hopefully fuel economy will improve also

Haha... for me obvious for engine response & more bassy for audio. But don't hope much for fc cos maybe will increase slightly only.

let me know when you plan to get your nightbreakers. lets bulk ive pm-ed "airline" he quoted rm 80 for a pair. duno if he does cod anot.

@satria89
if ur aiming for better low-end torque, improvement of FC, lighter engine response while air-cond is on.. sure thing its a recommended parts.. btw i also installed LCP in my car.. mythelogy.. my FC from 530km/full tank improves to 590-610km/full tank mix driving of city and highway.. if 100% city drive before 450km/full tank now can get 500-520km/full tank.. and to say that my car is auto tranny with 17" sport rim..

Yeap. Speaking of tyres, I'll have to change mine in Jan.
Any recommendation on type and brand? I'm looking at 195/60/R15.
Price as well? and WherE?

195/50/15 for waja? Too Thin alr. Tyre shop recommend 55/60.

correct, cps is using 60 series
some prefer comfort rather than racing ma, so its depends on individual driving style lo.
mine was 60 because it use to be my old man who drives it ma...now changing to 16" without his consent, sure kena marah kao kao later on, but who cares? kena marah is short-term only, changing the rim is long term thing    bad son 

For ppl who wan comfort sure go for bigger tire. Like to drift or play cornering sure go for thin tire. Depend on which u prefer ba.

no picture for 50series, but got pictures for other stuffs

just now i was bathing with my engine cover, then it becomes like this


after looking at sam's, i felt so inferior of mine... so i decided to clean it. so next time when we meet up again, at least i wont feel so embarrass to pop up my engine hood.

its not that clean because the stains had been there for years, will have to clean it again next time when i'm back to my hometown.

from what i heard, the original rim is 9kg each, and standard taiwan rim only weight 7kg which is good enough, you dont want too light, that will cause your rim to bend whenever you are driving in malaysia's road, any road! but i'm sure 15" wont get bend that easy.
the original rim i meant was the very first batch waja rim, the fugly one.

just loosen the four bolts u see on the picture, and remove the cover

Rainbow HID Kit 4300k

Who interested please add your name & post the details together. nayte dun scold me cos i put u in the list >.<

2010 Bulk Purchase Mission

1. swk_sam (Sam)
2. nayte (Nicholas)
COD Location : Pending....
Date : Pending....
Time : Pending....

Price : RM200 (MAYBE can reduce more)
Installation : Ken will help us to install only for headlamp cos he dunno how to install foglamp.

CPS ori headlamp is with HID 4300k installed. All of us also dun wan JPJ kacau us, but andy mention can go thru any block without problem. Thats y we decided to get HID 4300k. Only changing bulb not good enuff for Waja. Come join us for BP