Hi everyone. I'm new to the forum but from what i can see it's a good one.

I have some enquiries re the Xiggy Thor's Hammer.

I purchased my Thor's Hammer on 12/10/2010 from a dealer in Imbi. The base looked flat,i.e it did not let any light through between the aluminium shims, and the
base had been ground so the nickel plate was removed showing the machined copper finish. Can i take this to be Version 2? How do i positively identify it as one?

Also, i read here that though the TX-3 TM compound is supposedly the more advanced one from Tuniq, the earlier TX-2 works better for HDT cooler because it's higher viscosity
allows it to permeate the gutters between the aluminium shims and heatpipes well, making an effective heat conducting interface. TX-3's lower viscosity makes this
harder to achieve.

Correct?

Are any further mods required on The thor's Hammer if it is version two?

Thanks