Try updating your mobo bios 1st....
but u need to check your mobo revision no. refer at this link http://www.ecs.com.tw/extra/productinfo/MB.htm
then pick appopriate BIOS for your mobo here... http://www.ecs.com.tw/ECSWebSite/Downloads...enuID=6&LanID=0

Your processor suppossed to run at 2.4GHz 533MHz FSB(133MHz Internal)... with CPU/Bus ratio aka multiplier = 18

If updating the BIOS still doesnt fix the problem... u have to manually change your CPU PnP settings...

*Note: Flashing a BIOS is a risky process..

This post has been edited by campsol2k: Jun 9 2009, 04:34 PM

there are two actually... either mobo version or BIOS version.. where did get the version no. from? POST screen or on the board?
POST screen - BIOS version
Board - Mobo version/revision

Check both...

By looking at the CPU-Z screenshot... it is impossible that u have that kind of proc.... 604-pin xeon? It cant even fit into your mobo.. that must be some mistakes., rite?.. probably CPU microcode bug or something... i dont know....... possibility your mobo can't identified your CPU properly...that's why i need u to update your BIOS....

This post has been edited by campsol2k: Jun 9 2009, 06:27 PM

Unfortunately it seems that BIOS update for your mobo is unavailable. So no choice either
- u have to change the ratio and FSB clock manually... if your BIOS allows u to change those settings...
- change other board that support your proc...
- change other proc supported by your mobo...

This post has been edited by campsol2k: Jun 9 2009, 11:56 PM